Mitsubishi Electronics QJ7LP25G ユーザーズマニュアル
2 - 2 2 - 2
MELSEC-Q
2 SYSTEM CONFIGURATION
2.1.2 Setting items
(1) Table 2.1 lists the setting items on the master module of the remote master station
(MR) and the parameter setting items on GX Developer.
Table 2.1 Remote master station setting items
Setting items
Remote master station (M
R
) Reference
Network module switch
STATION NO.
0
Section 4.2.1
MODE
Section 4.2.2
Parameter setting on GX Developer
Setting the number of Ethernet/CC IE/MELSECNET cards
Network
type
MELSECNET/H
(Remote master station)
Section 5.1.1
Starting I/O No.
Section 5.1.2
Network
No.
Section 5.1.2
Total
stations
Section 5.1.2
Group
No.
—
Mode
Section 5.1.2
Common
parameters
Section 5.1.3
Supplementary
setting
Section 5.1.4
Station specific parameters
—
Refresh
parameters
1
2
Section 5.1.5
Valid module during other station access
Section 5.1.6
Interlink transmission parameters
—
Routing
parameters
3
: Always set, : Default setting, : Set as needed, : No need to set
1: Default values are not set in LX/LY. Set the refresh parameters.
2: Default values are preset for LB/LW.
2: Default values are preset for LB/LW.
The CPUs other than the Universal model QCPU may operate even if refresh
parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
3: Refer to the Q Corresponding MELSECNET/H Network System Reference
Manual (PLC to PLC Network) (SH-080049).
2