Marantz RC5200 ユーザーズマニュアル
User Guide
52
Troubleshooting
General Problems
The display is blank
n
Tap the screen to make sure the RC9200/5200 is turned on.
n
Adjust the contrast dial on the left side.
n
Make sure the batteries are properly installed.
n
Install new batteries or recharge the battery pack using the
recharging dock.
recharging dock.
The display is too light or too dark
n
Adjust the contrast dial on the left side.
The RC9200/5200 shuts itself off
n
This is a feature of the RC9200/5200 to save power. You can
change the length the RC9200/5200 stays on in the Settings
(see page 13).
change the length the RC9200/5200 stays on in the Settings
(see page 13).
Devices do not respond to commands from the RC9200/5200
n
Make sure the RC9200/5200 is in Use mode (see page 6).
n
Make sure the RC9200/5200’s sending eye is pointed towards
the device you’re operating.
the device you’re operating.
n
Check if the Low Battery icon is flashing. If so, replace the
batteries or recharge the battery pack.
batteries or recharge the battery pack.
n
Check if the button you are trying to use is programmed
properly (see page 18).
properly (see page 18).
n
Check if your device understands these particular Marantz
infrared codes. Re-add the device group with the correct model
number (see page 36).
infrared codes. Re-add the device group with the correct model
number (see page 36).
The RC9200/5200 beeps 4 times after inserting the batteries
n
Use RCEdit Touch Screen Setup to update the RC9200/5200’s
software (RCEdit > Tools > Update).
software (RCEdit > Tools > Update).
Programming Problems
Buttons are not sending the correct commands
n
Check whether the button is programmed globally or per device
(see page 31).
(see page 31).
Macros or Tab Style Jump buttons do not work
n
Make sure the RC9200/5200’s sending eye is pointed towards
the device the entire time the macro is being executed.
the device the entire time the macro is being executed.