Marantz RC1200 ユーザーズマニュアル

20

 ON 

 OFF

 ON / OFF

 SOURCE

 MACRO 

 MODE 

LEARNING  REMOTE

CONTROL  RC 

1200

To go ahead with the clearing operation,
release the buttons, and press the 

Cursor button ⁄0.
Once the data is cleared, the codes are
either returned to their original display or
left empty.  LCD is similarly returned to its
factory preset or left empty.  All the macro
programs are also cleared.
• T o   c a n c e l   t h e   m e m o r y   c l e a r i n g

operation, do not press the 

Cursor

button ⁄0 and simply touch any other
button.

After the 

Cursor button ⁄0 is pressed,

clearing the entire memory will take
approximately 10 seconds.

Macros make it possible to use a single
function button to perform more complex
series of operations that would normally
require pressing several buttons. A single
button can be programmed to perform up to
10 steps in sequence. A typical example of
such a series might be as follows:
• Turn the main amplifier power ON 

→

 Switch

the function to DVD 

→

 Set the Surround

Mode to Pro Logic 

→

 Switch the TV to video

input 

→

 Set the DVD player to PLAY.

• No signals may be transmitted during

macro programming.

• The various steps that make up a macro are

set initially to be sent one after another in 1
second intervals, however these intervals
may be shortened to as little as 0.5 seconds
or lengthened to as much as 5 seconds
using the Setup mode.

• In the macro mode, the number of steps the

macro contains is displayed on LCD 

c.

Macros may be programmed for each of the
11 function buttons, from LD to AMP.

Use a ballpoint pen or other sharp point to
press the 

button  x until the

and 

indicators are

displayed blinking on the LCD.