Universal Remote Control MRF-260 ユーザーズマニュアル
Page 3
Installation
1. Unplug the MRF-260. Test all IR commands and macros line of
sight.
2. Power on all AV components including the TV. Turn on all of the
lights and lower all dimmers to 50%. Power on anything that
may create RF Interference (particularly devices with high speed
microprocessors or hard drives).
may create RF Interference (particularly devices with high speed
microprocessors or hard drives).
3. Check that the address wheel on the rear of the MRF-260 is set
to ID#0 (the interference “sniffing” position).
4. Connect the MRF-260 to its DC wall adapter and plug the wall
adapter into a live AC outlet. Place the MRF-260 in a location at
least 3 feet away from satellite receivers, cable boxes, HDTV
tuners, DVRs, PCs or any other device with a high speed micro-
processor (these generate broad band Radio Frequency
Interference -RFI). Of course, you should keep in mind that the
emitter cables are 10’ long.
least 3 feet away from satellite receivers, cable boxes, HDTV
tuners, DVRs, PCs or any other device with a high speed micro-
processor (these generate broad band Radio Frequency
Interference -RFI). Of course, you should keep in mind that the
emitter cables are 10’ long.
MRF-260 B
ASE
S
TATION
Check that the arrow pointer in the center of the wheel is pointed to 0, the
default “interference sniffing” position. If it is not, use a small flat blade
screwdriver (included) to set the RF ID# to 0.
default “interference sniffing” position. If it is not, use a small flat blade
screwdriver (included) to set the RF ID# to 0.
The green POWER LED indi-
cates that the MRF-260 is
powered on.
cates that the MRF-260 is
powered on.
The red STATUS LED flashes
differently, based on the
Address setting:
differently, based on the
Address setting:
IF SET TO ID#0
The Status LED flashes
when it receives ANY RF
signal, including RFI. This
makes ID#0 ideal for “sniff-
ing” out RFI.
The Status LED flashes
when it receives ANY RF
signal, including RFI. This
makes ID#0 ideal for “sniff-
ing” out RFI.
IF SET TO ANY OTHER ID#
The Status LED flashes ONLY
when it receives a correctly
addressed RF command.
The Status LED flashes ONLY
when it receives a correctly
addressed RF command.