AT&T A10 ユーザーズマニュアル

STEP 1.  Power on the device you want to program 

STEP 2.  Locate the 4-digit code from the provided

               code list. 

STEP 3.  Press and hold the mode key (TV, DVD, or AUX)

               and while holding the mode key, press the ok key.

STEP 4.  Release both the mode key and the OK key. 

                All the mode keys fl ash but the selected

               mode key stays on.

STEP 5.   Enter the 4-digit code from the code list.  The

               selected mode key light blinks for each digit 

               entry and remains off after the entry of the 

                fourth digit

STEP 6.  Point the remote control at the selected device

                and press the power key once.  The device 

                should turn off if you have found the correct 

                4-digit code.

STEP 7.  If there are multiple codes and one does not

                work, repeat steps 1-5 using the next code 

                until you fi nd the correct one.  If it still does not 

                work as intended, please refer to your users

                manual.

STEP 1.  Place the remote control in the Base 

                Station.

STEP 2.  Make sure that the charging points are in

               full contact by seeing the charging lights

                move.

     It is not necessary to charge the remote

               control often, but remember to place it in 

               the Base Station at least one overnight 

                session per month if possible. Quick 

               charge the remote in 30 minutes or fully 

               charge the remote in 12 hours.

Save your codes.

STEP 1.  If you have misplaced the remote

               control, simply press the AT&T globe

               on the Base Station (the remote control

               will fl ash several keys and play a ring

               tone)

STEP 2.  Once you have located the remote

               control, press any button to stop the

               sound and fl ashing keys.

STEP 1.    Determine where you would like to

                 place the Base Station.

STEP 2A.  If the location is less than 3 feet from

                 the U-verse receiver, connect the

                 “square” end of the supplied USB cable

                  to the Base Station and the “rectangle”

                  end to the back of the U-verse receiver.

STEP 2B.  If the location is more than 3 feet from 

                 the U-verse receiver, connect one end 

                  of the supplied plug-in power supply to

                  the Base Station and the other end to a 

                  near by wall socket.

STEP 1. Use the +H and the +M buttons on the

               bottom of the Base Station to set the

              hours and minutes of the clock.

STEP 2. With the remote control in the Base Sta-

               -tion, press and hold the fi nd button which

               will cause the clock to dim as desired.

              Press and hold fi nd button again to make

              clock brighter as desired.