Philips VRA671AT ユーザーズマニュアル

The Number buttons won’t work for channels above 69.
•  Enter channel numbers as a two-digit number. If you want to select channels 100 and above, enter chan-

nel numbers as a three-digit number. Details are on page 25.

TV programs cannot be watched normally.
•  Put the VCR in TV position. (Press the VCR/TV button so that the VCR light disappears from the display

panel. Details are on page 28.)

•  Check the connections between the VCR, TV, antenna/cable, and Cable Box/Direct Broadcast System (if

applicable). Details are on pages six-10.

Tape cannot be inserted.
•  Insert the tape, window side up, with the record tab facing you.
•  Make sure a tape isn’t already in the VCR by pressing the STOP/EJECT button on the VCR.
•  Gently push on the center of the tape when putting it in the VCR. Never force the tape into the VCR.
•  If a timer recording is programmed and the VCR power is off, you can not insert a tape without a

record tab.

Tape cannot be removed.
•  Make sure the power plug is connected completely to a power outlet.

VCR ejects the tape when the REC(ord)/OTR button is pressed or when the VCR power is
turned off to set a timer recording.
•  Make sure the tape has a record tab (page five).

Poor reception
•  You may need to tune your TV again.

The motor (cylinder) rotates even when the VCR is in Stop mode.
•  To enable the quick play mechanism, the cylinder will rotate for about five minutes. This is normal. The

quick play mechanism enables the tape mechanism to switch from Stop mode to Play mode in one sec-
ond.

Line Input mode
•  If you accidentally enter Line Input mode (AV FRONT or AV REAR will appear on your TV screen

briefly), press the CH(annel) o/p button or use the Number buttons to select another channel.

Hi-Fi Stereo Sound
•  During playback, Hi-Fi audio may temporarily revert to normal audio when you adjust tracking.  This is

normal.

•  When connecting the VCR to a stereo TV, you will only get stereo sound if you use audio cables to con-

nect the AUDIO OUT jacks on the VCR to the AUDIO IN jacks on your TV. Make sure the TV is in
Line (Auxiliary) Input mode.

•  When you connect the AUDIO OUT jacks on the VCR to the AUDIO IN jacks on your TV, the stereo

light on the TV might not glow.  But, as long as the VCR status display indicates you are receiving a
stereo signal, you are receiving a stereo signal.  This is normal.

•  Only tapes recorded in Hi-Fi audio will play back in Hi-Fi audio.  Tapes recorded in normal audio will

play back in monaural (single sound source) audio.