Philips VR620/07 ユーザーズマニュアル
40
TIMER
VPS
DATE
REP.
PROG. START PDC END
21
MO-FR
01
20:00
]
21:30
________________________________
REP.pSELECT
REP.pSELECT
STOREpOK
aThe following message appears on the screen: 'SELECT PROG.
NR.'
b The programme number of the TV channel has not yet been assigned to
the PlusCode number. Using the number buttons
0-9
on the remote
control, select the corresponding programme number (programme name)
of the TV channel and confirm with
of the TV channel and confirm with
OK
.
aThe following message appears on the screen: 'PLUSCODE NUMBER
NOT VALID'
b The entered PlusCode number is incorrect. Correct your instructions or
end with
MENU
.
b Check the time/date (see chapter 'Installing your video', section 'Setting the
time and date').
aThe following message appears on the screen: 'MO-FR
PROGRAMMING NOT POSSIBLE FOR WEEKEND'
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
5
The decoded data appears after confirmation. You can go back to
change the data. Select the corresponding input field using P or
change the data. Select the corresponding input field using P or
Q . Change the data with ;qP , P r= or with the number
buttons 0-9 .
Switching on 'VPS/PDC' in the 'START' input field
Select the 'START' input field using
P
. Using
SELECT
switch on
'VPS/PDC' (']' lights up). If you press
SELECT
again, you will switch
'VPS/PDC' off (']' goes out).
6
When all informations are correctly, confirm with
OK . The
programming information is stored in a TIMER block.
7
Insert a cassette with an intact security tab (unprotected).
Using 'Tape List'
To save a recording in the 'Tape List' or to use a 'Tape List' cassette, enter
the cassette number using the number buttons
the cassette number using the number buttons
0-9
on the remote control.
The cassette is being checked. You can find more information on the 'Tape
List' in the chapter 'Tape List'. If you don't use the Tape List, interrupt with
List' in the chapter 'Tape List'. If you don't use the Tape List, interrupt with
STOP h
.
8
Switch off with STANDBY/ON m .
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video
recorder display.
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video
recorder display.
Programming a recording (TIMER)