Radio Shack 62 (16-632) ユーザーズマニュアル

21

To watch a broadcast using the TV’s tuner, turn
off the VCR, or repeatedly press 

 until

VCR disappears from the VCR’s display.

Note: If you are using a TV/monitor connected
to the VCR’s 

 jacks, be sure

to set the TV/monitor to the TV mode.

The antenna or cable signals pass through the
VCR unaffected, as if the antenna or cable
were connected directly to the TV. Use the TV
as you normally would.

Your VCR can receive up to 68 VHF and UHF
channels, and up to 125 cable channels. The
VCR displays the channels as 1–125.

• Channels 2–13 are the same for VHF and

cable TV, and cable companies usually
number them as they appear on the dis-
play.

• Since cable companies sometimes desig-

nate cable channels with letters or letter-
number combinations, a channel number
you see on the VCR’s display might differ
from the channel number displayed on
your cable box. You might need to experi-
ment to determine the proper cable chan-
nel designations for your cable system. For
more information, contact your local cable
company.

• Two of the cable channels are designated

for audio only.

1. Turn on the TV and set it to the same chan-

nel as the VCR’s 

 switch.

Note: If you are using a TV/monitor con-
nected to the VCR’s 

jacks, set the TV/monitor to the video
mode.

2. Repeatedly press 

 until VCR

appears.

3. To manually select a channel, you can

press 

s or 

 t to have the tuner auto-

matically advance to the next channel
stored in the tuner’s memory.

Note: If you press 

 s when the tuner is

at the highest programmed channel or 

 t

when the tuner is at the lowest pro-
grammed channel, the VCR enters the
audio/video mode and 

 (

 or

 on the Model 62) appears on the

TV (see “Selecting the Signal to Record”
on Page 28). Continue to press 

 s or 

t until the highest or lowest programmed
channel appears.

Or, to directly select a channel, press the
number buttons on the remote control for
the desired channel.

• Precede a single-digit number with a 0

— for example, 01, 02, and so on.

• To enter a three-digit number, press 

,

then enter the second and third digits in
the channel number.

• (Model 62 only) If you receive MTS ste-

reo or SAP broadcasts, see “Receiving/
Recording Stereo/SAP Broadcasts
(Model 62 Only)” on Page 28.

16-549.fm  Page 21  Tuesday, July 20, 1999  5:04 PM