Philips LTC 3963/51 ユーザーズマニュアル

SETTING THE TIME AND DATE
Use the CLOCK SET display to set the date and time.

1. Press the START/STOP button so that [CLOCK

SET] flashes on/off.

2. Press the SET button.  The day flashes on/off.
3. Press the UP or DOWN button until the desired

number appears on the monitor.

4. Press the SET button.  The month flashes on/off.
5. Press the UP or DOWN button until the desired

number appears on the monitor.

6. Press the SET button.  The year flashes on/off.
7. Press the UP or DOWN button until the desired

number appears on the monitor.

8. Press the SET button.  The hour flashes on/off.
9. Press the UP or DOWN button until the desired

number appears on the monitor.

10. Press the SET button.  The minutes flash on/off.
11. Press the UP or DOWN button until the desired

number appears on the monitor.

12. Press the START/STOP button: the seconds will

start counting and the clock will start. [CLOCK
SET] will flash on/off again at this time.

13. To display the time/date you have set here on

the monitor screen, press the START/STOP but-
ton again to cause [OPTIONS] to flash, and then
proceed with step 2 in item on OSD TYPE on
page 15.

14. Press the START/STOP button three times.

• Make sure that letters [CLOCK SET] or

[OPTIONS] are not flashing.

Notes:
• Perform the same procedure as when setting the

time and date to make corrections after having
set them.  The minutes flash on/off when the SET
button is pressed (in step 2 above).

• To record time and date on the tape, display them

on the monitor screen.  If they are not displayed
on the monitor, they cannot be recorded on the
tape.

❲

❳

❲

❳

TIME (HOUR, MINUTE, SECOND)

DATE (DAY, MONTH, YEAR)

DAY OF WEEK:  Corrected 

automatically to 
match  the input 
date.

OSD TYPE (OFF, FULL or HALF)

TIME ADJUST (MASTER or SLAVE)