Multiquip DCA25USI2XF ユーザーズマニュアル

There are two 120 VAC, 20 amp GFCI  (Duplex Nema 5-20R)
recepacles provided on the output terminal panel.  These
receptacles can be accessed in any 

position.  Each receptacle is protected by a 20 amp circuit
breaker. These breakers are located directly above the GFCI
receptacles. Remember the load output (current) of both
GFCI receptacles is dependent on the load requirements of
the U, V, and W output terminal lugs.

Pressing the 

reset button resets the GFCI receptacle after

being tripped.   Pressing the 

Test Button (See Figure 9) in

the center of the receptacle will check the GFCI function.
Both receptacles should be tested at least once a month.

Each auxilliary receptacle is protected by a 50 amp circuit
breaker. These breakers are located directly above the GFCI
receptacles. Remember the load output (current) on all three
receptacles is dependent on the load requirements of the
Output Terminal  Lugs.

Turn the 

voltage regulator control knob  (Figure 11) on the

control panel to obtain the desired voltage. Turning the knob
clockwise will

 increase the voltage, turning the knob counter-

clockwise will 

decrease the voltage.

There are three 120/240V, 50 amp auxilliary twist-lock
(CS-6369) recepacles (Figure 10) provided on the output
terminal panel.These receptacles can 

only be accessed

when the voltage selector switch is placed in the 

The UVWO terminal lugs are protected by a plastic face
plate cover (Figure 12). Un-lock the locking latch, and lift the
terminal cover to gain access to the plastic face plate.
Remove the screws securing the face plate to the terminal
enclosure, then lift the plastic hinged face plate.

After the load wires have been securely attached to the
UVWO terminals, reinstall the plastic face plate. Place the
terminal cover in the down position and secure the locking
latch.