JVC 0302MNV*ID*JVE ユーザーズマニュアル
Masterpage:Right
EN
9
Filename [HRS5950EU1-EN.fm]
Page 9
December 4, 2001 5:14 pm
INSTALLING YOUR NEW RECORDER
Basic Connections
It’s essential that your video recorder be properly
connected.
connected.
A
Check the contents.
Make sure the package contains all of the accessories
listed in “SPECIFICATIONS” on page 54.
listed in “SPECIFICATIONS” on page 54.
B
Situate the recorder.
Place the recorder on a stable, horizontal surface.
C
Connect the recorder to TV.
The connection method you use depends on the type of
TV you have.
TV you have.
RF Connection
8 To connect to a TV with NO AV input connectors . . .
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANT. IN connector
on the rear panel of the recorder.
C Connect the provided RF cable between the RF OUT
connector on the rear panel of the recorder and the
TV’s aerial connector.
TV’s aerial connector.
AV Connection
8 To connect to a TV with AV input connectors . . .
A Connect the aerial, recorder and TV as per “RF
Connection”.
B Connect an optional 21-pin SCART cable between the
L-1 IN/OUT connector on the rear panel of the
recorder and the TV’s 21-pin SCART connector.
recorder and the TV’s 21-pin SCART connector.
D
Connect the recorder to mains.
Plug the end of the mains power cord into a mains outlet.
Make AV connection if your TV has a 21-pin AV input
connector (SCART) in order to reduce the possibility of
interference. With AV connection, you can enjoy
stereo playback of video tapes if you are using a stereo
TV.
connector (SCART) in order to reduce the possibility of
interference. With AV connection, you can enjoy
stereo playback of video tapes if you are using a stereo
TV.
NOTES:
● The L-1 IN/OUT connector accepts only a composite
signal (regular video signal) and delivers either a composite
signal (regular video signal) or a Y/C signal (a signal in
which the luminance and chrominance signals are
separated). If your TV’s 21-pin AV input connector (SCART)
is compatible with the Y/C signal, set “L-1 OUTPUT” to
“S-VIDEO” after the connection and the initial settings are
completed (
signal (regular video signal) or a Y/C signal (a signal in
which the luminance and chrominance signals are
separated). If your TV’s 21-pin AV input connector (SCART)
is compatible with the Y/C signal, set “L-1 OUTPUT” to
“S-VIDEO” after the connection and the initial settings are
completed (
墌
pg. 30). You can obtain high-quality S-VHS
pictures. (For connection, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.)
cable that is compatible with the Y/C signal.)
● Set your TV to the VIDEO (or AV), Y/C, or RGB mode
according to the type of your TV’s SCART connector.
● For switching the TV’s mode, refer to the instruction
manual of your television.
Aerial connector
Back of TV
21-pin SCART
connector
connector
TV aerial
cable
cable
RF cable
(provided)
21-pin SCART
cable
(not provided)
cable
(not provided)
Mains power cord
Mains outlet
Back of recorder
L-1 IN/OUT
ANT. IN
RF OUT
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
VIDEO OPERATION CAN BE PERFORMED.
After the connection is completed, perform “Auto Set
Up” on page 10.
Up” on page 10.
HRS5950EU1-EN.book Page 9 Tuesday, December 4, 2001 5:32 PM