A&D UC-321PBT-C ユーザーズマニュアル
4
Pairing The PBT-C Series Device With a Continua-Compliant Manager
Model UC-321PBT-C is a PBT-C series device. PBT-C series devices are
designed to be connected only with Continua Managers.
To pair the device with a Manager, please follow these steps:
designed to be connected only with Continua Managers.
To pair the device with a Manager, please follow these steps:
1. Remove the four AA batteries from the device.
2. Discharge the device completely by trying to take a measurement. Press the
“Measurement” switch, tap the toe switch, or tap the surface of the device as
appropriate.
Note: the measurement will not proceed and the LCD will remain blank.
appropriate.
Note: the measurement will not proceed and the LCD will remain blank.
3. Insert the four AA batteries back into the device.
4. Refer to the Manager’s instruction manual to start a Bluetooth discovery and
inquiry process.
The device will stay discoverable for 60 seconds following battery insertion.
If the Manager fails to pair with the device, repeat steps 1 through 3.
The device will stay discoverable for 60 seconds following battery insertion.
If the Manager fails to pair with the device, repeat steps 1 through 3.
5. Once the manager has discovered the device, enter the PIN “123456” as a
password to finish the pairing process.
When the Manager supports SSP (Secure Simple Pairing), no password is
required for the pairing process.
When the Manager supports SSP (Secure Simple Pairing), no password is
required for the pairing process.
A device that has been certified by Continua displays this
logo.
logo.
A Bluetooth device has the logo mark of Bluetooth printed
on it.
on it.
The RoHS (Restriction of Hazardous Substances)
Directive
Directive