Escali E30CB ユーザーズマニュアル
2. Installation and Details for Caution Use
* Unless you follow the cautions properly, there may be life damage or material damage.
Correct Installation Procedures
z
This instrument is intended for indoor use only.
z
Install in areas with no influence of heat, such as direct ray of light and heater.
z
Install away from areas with either strong magnetic force or electrical noise.
z
Install on a flat and vibration-free platform.
z
Install in areas with no dusts and moistures.
z
Install in areas with no wind currents and radical thermal alterations.
z
This instrument is not suitable for use at altitude above 2000m.
Details for Caution Use – Make sure to check the power source before use.
z
Use a soft cloth with appliance of alcohol when polishing the scale.
z
Keep out water or any liquid-type substance from the scale.
z
Check to see if the scale is placed horizontally before use. If the scale is not in a horizontal position, use the horizontal positioning screw in order to adjust its position.
(Have the foam inside of the level gauge be in the center.)
z
z
When the scale is turned on, the display will be set to initial scaling condition after indicating RB-XX.
In order to maintain its electrical safeties, warm up the machine for approximately 10 minutes before use.
z
Make sure the weight display is set to " 0 g " before use. If the display is not set to " 0 g ", use after setting the display to " 0 g " by pushing the "Zero/Tare" key.
z
Use only authorized adapter.
z
Use same kinds of batteries when using batteries.
z
Remove the battery from the scale if not using the scale for a long time. It may cause damage to the scale from the leak of zinc-air battery.
z
Weighing by over maximum capacity may cause damage to the scale.
z
This scale needs periodical inspection every two years.
z
Never reorganize, repair or disassemble this scale. Inquire of a manufacturer of a distributor about after service.