Motorola I580 ユーザーズマニュアル

FIELD LEVEL TEST MODES AND PROCEDURES:  Bit Error Rate (BER) Test

68P80401P05

Use this test on a unit having any of the following symptoms: resets (RAAAA Type), No Service 
failures.

 

1.

Confirm the reset log has errors.

2.

Place the unit into Test Mode for this test.

3.

Watch the unit for resetting during this procedure.

4.

Verify the R-2660 has been calibrated and cable continuity is good.

5.

In the United States, the Main board can only be replaced and 

 

programmed at the factory or iDEN Radio Support Center.

6.

The Power, MPX, and MOD test parameters are for factory use 

only and should not be adjusted by field service personnel (see page 
7-2

 

for default values).

Fail

Unit passed test. Look for system, cover-

age, accessory, or software problems.

Fail

Press Start

on unit. Press TX ON. The

RX BER that appears on the display

should be 0.0% at -70 dBm. Verify that

the TX BER on the R-2660

is < 0.07%.

Pass

Connect the battery eliminator to the 
unit. Remove the antenna. Set power 

supply between 5.0 and 12.0 Vdc.

Power up the unit. Enter Test Mode.

 

Do the following:

 

   1. Press the Menu key, and then the Edit option key.
   2. Press the Change option key, and scroll down to 800BER1.
   3. Press Select to select the test.
   4. Press the Back key, and then press Menu.

Fail

Pass

Lower

Gen: to -109 dBm

and check the RX BER in the

display. The BER should be less than 10% 

when at Gen: -109 dBm. (Freq

Error should be less

than 200 Hz.)

Set up the R-2660 for iDEN BER 

Test, and connect the unit to the RF 

IN/OUT connector.

Replace the

Main board, and 

repeat the test.

Replace the

Main board, and 

repeat the test.

Replace the

Main board, and 

repeat the test.

The monitor frequency is 806.0125 
(Carr#1) for BER1.

Repeat the

above test using

800BER2, 800BER3,

and 900BER3 in Test Mode. 

The monitor frequency is 813.5125

(Carr#601) for 800BER2, 820.9875 (Carr#1199)

for 800BER3, and 824.9875 for 800BER4. 

The monitor frequency is 896.01875 for

900BER1, 898.51875 for

900BER2 and

900.98125 for

900BER3.

Note: Ensure that the maximum cable 
loss does not exceed 2 dB.

Note: Change offset on R2660 to +39 MHz for 900 

MHz (900BER1, 900BER2, and 900BER3).