Motorola G24 ユーザーズマニュアル
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-31
Example
AT+CCFC=?
+CCFC: (0,1,2,3,4,5)
OK
AT+CCFC=0,3,"01256316830",129,1
OK
AT+CCFC=1,3,"0545658278",129,1//Register UC forward-to of all classes.
OK
AT+CCFC=1,1//Activate UC forward-to of all classes.
OK
AT+CCFC=1,2 //Interrogate reason not-reachable of all classes.
+CCFC: 1,1,"+97254151200",145
+CCFC: 0,2,"",0
+CCFC: 0,4,"",0
OK //For <reason>=3, forward only voice calls is activated.
AT+CCFC=4,2//Interrogate reason all-call-forwarding for all classes.
+CME ERROR: no network service//Interrogation of <reason>=30 is not supported by network.
AT+CCFC=2,3,"+972545658278"
OK
AT+CCFC=2,0//Disable call-forwarding for reason no-reply of all classes.
OK
AT+CCFC=2,2
+CCFC: 0,1,"+972545658278",145,,25
+CCFC: 0,2,"+972545658278",145,,25
+CCFC: 0,4,"+972545658278",145,,25
OK
+CLIR, Calling Line Identification Restriction
This command instructs the G24 to query, enable or disable the presentation of the CLI (calling
line ID) of a MO call to the called party. The restriction of the CLI (disable presentation) is
dependent both on the G24 and on the network.
line ID) of a MO call to the called party. The restriction of the CLI (disable presentation) is
dependent both on the G24 and on the network.
The network enables three possible provisions of CLIR:
•
Not provisioned (CLIR Off - presentation allowed)
•
Provisioned permanently
•
Provisioned with Temporary mode
The provision is fixed and cannot be changed by an AT command.
Temporary Mode:
Temporary mode can be in one of two states:
•
A - Presentation restricted (CLIR On) as default.
•
B - Presentation allowed (CLIR Off) as default. A subscriber to Temporary mode always has
a default subscription to state A or B. Temporary-mode provisioning means that the terminal
can request the G24 to switch the default mode from A to B, and vice versa.
a default subscription to state A or B. Temporary-mode provisioning means that the terminal
can request the G24 to switch the default mode from A to B, and vice versa.
Note:
When a service is in state A, and the terminal wants to enable the CLI presentation (turn
CLIR off) for a single call, it can do so using the ATD command. This does not change
CLIR off) for a single call, it can do so using the ATD command. This does not change