Motorola G24 ユーザーズマニュアル
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-273
Modem Configuration and Profile
Modem Register Commands
The G24 holds certain data items in selected memory space, named Software Registers
(S-registers) and Modem Registers. Some of these registers are used as bitmaps, where one
register holds more than one data item.
(S-registers) and Modem Registers. Some of these registers are used as bitmaps, where one
register holds more than one data item.
All S-registers can be accessed using the S command, described in
. Some registers can also be accessed using dedicated commands, detailed below.
V, G24 Response Format
This command determines the response format of the data adapter and the contents of the header
and trailer transmitted with the result codes and information responses. This command also
determines whether the result codes are transmitted in a numeric or an alphabetic ("verbose")
form. The text portion of information responses is not affected by this setting.
and trailer transmitted with the result codes and information responses. This command also
determines whether the result codes are transmitted in a numeric or an alphabetic ("verbose")
form. The text portion of information responses is not affected by this setting.
The following table shows the effect that setting this parameter has on the format of information
text and result codes.
text and result codes.
Table 3-180: Effects of Parameter Settings
V0
V1
Information Responses
<ATV0><cr><lf>
<ATV1><cr><lf>
0 - "OK"
1 - "CONNECT"
2 - "RING"
3 - "NO CARRIER"
4 - "ERROR"
5 - "NO DIALTONE"
6 - "BUSY"
7 - "NO ANSWER"
1 - "CONNECT"
2 - "RING"
3 - "NO CARRIER"
4 - "ERROR"
5 - "NO DIALTONE"
6 - "BUSY"
7 - "NO ANSWER"
<numeric
code><cr><if>
code><cr><if>
<verbose code><cr><lf>
Command Type
Syntax
Response/Action
Remarks
Set
ATV<value>
OK
or:
+CME ERROR: <err>
The Set command sets the format of
information responses and result
codes.
information responses and result
codes.
Read
ATV?
<current value>
The Read command reads the current
setting of response format.
setting of response format.
Test
The Test command for V is not
defined, and therefore is not supported
by the G24. The G24 returns an error.
defined, and therefore is not supported
by the G24. The G24 returns an error.