Motorola G24 ユーザーズマニュアル
GPRS/EDGE
3-356
AT Commands Reference Manual
December 31, 2007
+MCEG, Motorola Control EGPRS
This AT command is used to enable or disable EGPRS support in G24 modules with EDGE
support capability.
support capability.
The command works only in G24 customer models with EDGE capability. The phone restarts 10
seconds after the SET command execution completed. The changes take effect after restart.
seconds after the SET command execution completed. The changes take effect after restart.
The following table shows the +MCEG parameters.
Example
AT+MCEG=?
+MCEG: (0-1)
OK
AT+MCEG=0
OK
AT+MCEG?
+MCEG: 0
OK
AT+MCEG=1
OK
AT+MCEG?
+MCEG: 1
OK
Command
Type
Syntax
Response/Action
Remarks
Set
AT+MCEG=<n>
OK
or:
+CME ERROR: <err>
The SET command used
for setting the current
EGPRS support state.
for setting the current
EGPRS support state.
Read
AT+MCEG?
+ MCEG : <n>
OK
or:
+CME ERROR: <err>
The READ command
returns the current
EGPRS support state
<n>.
returns the current
EGPRS support state
<n>.
Test
AT+MCEG=?
+ MCEG : (0-1)
OK
or:
+CME ERROR: <err>
The Test command
returns the possible
values' range.
returns the possible
values' range.
Table 3-227: +MCEG Parameters
<Parameter>
Description
<n>
Indicates the EGPRS support state (enabled or disabled)
0
0
Disable EDGE support.
1
Enable EDGE support.