Motorola i1000 ユーザーズマニュアル

         GETTING STARTED

 

 

i1000

The NTN8653A Desktop Rapid Charger will charge Motorola 
authorized batteries listed on page 59 for the i1000. To charge a 
battery, refer to Figure 3 and follow the procedure below:

  1.  Plug the flat end of the power-supply cord into the receptacle on 

the back of the charger.

  2.  Plug the transformer end of the power-supply cord into any 

standard AC wall outlet. The charger performs a quick power-
up self-test, during which the LED indicators will flash once to 
indicate a successful power-up.

  3.  Insert an i1000 portable with an attached battery, into the 

charger's front pocket. This is done by inserting the bottom of 
i1000 portable onto the pin connector in the bottom of the 
charger's front pocket.

  4.  If the portable is properly seated in the front pocket, the 

charger’s front pocket LED indicator will light red to indicate 
that the battery is being charged. (If a battery is in the rear 
pocket and the portable with a battery is inserted into the front 
pocket, the rear pocket’s LED flashes yellow, indicating that its 
battery is waiting to be charged.) 

  5.  The charger has the capability of displaying the battery’s charge 

status. The indicator will show the following: solid red=1-30%; 
solid yellow=31-60%; flashing green=61-90%; solid green=91-
100%.

 

Rear Pocket

Front Pocket

Pin Connector

Power supply cord receptacle

LED
Indicators

Accessories

i1000  Page 63  Wednesday, June 17, 1998  1:53 PM