Motorola MC70 ユーザーズマニュアル
2 - 22 MC70 User Guide
Figure 2-17
Linear Scanning
3.
Press the scan button. Ensure the red scan beam covers the entire bar code. The Scan/Decode LED lights
red to indicate that scanning is in process, then lights green and a beep sounds, by default, to indicate the
bar code was decoded successfully.
red to indicate that scanning is in process, then lights green and a beep sounds, by default, to indicate the
bar code was decoded successfully.
Figure 2-18
Linear Scanner Aiming Pattern
Imager Scanning
1.
Ensure that a scan-enabled application is loaded on the EDA.
2.
Aim the scan window at the bar code.
Figure 2-19
Imager Scanning
3.
Press the scan button. The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is
within the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate
that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was
decoded successfully. Note that when the EDA is in Pick List Mode, the imager does not decode the bar
code until the crosshair touches the bar code.
within the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate
that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was
decoded successfully. Note that when the EDA is in Pick List Mode, the imager does not decode the bar
code until the crosshair touches the bar code.
Incorrect
Correct