Motorola 2200 ユーザーズマニュアル

n] vpi { 0 ... 255 }  

Select the vir tual path identifier (vpi) for VCC n.

Your Ser vice Provider will indicate the required vpi number.

n] vci { 0 ... 65535 }

Select the vir tual channel identifier (vci) for VCC n. Your Ser vice Provider will indicate the required vci num-
ber.

Select the encapsulation mode for VCC n. The options are:

Your Ser vice Provider will indicate the required encapsulation mode.

Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The total number of 
pppoe-sessions and PPPoE VCCs configured must be less than or equal to eight.

Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to for ward non-TCP/
IP traffic from one network to another. When bridging is enabled, the Motorola Netopia® Gateway maintains 
a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are dropped. If the bridg-
ing table fills up, the oldest table entries are dropped to make room for new entries. 

Vir tual circuits that use IP framing cannot be bridged.

☛  

For bridging in the 3341 (or any model with a USB por t), you cannot set the 

bridge option off, 

or 

bridge ethernet option off; these are on by default because of the USB port.

ppp-vcmux

PPP over ATM, VC-muxed

ppp-llc

PPP over ATM, LLC-SNAP

ether-llc

RFC-1483, bridged Ethernet, LLC-SNAP

ip-llc

RFC-1483, routed IP, LLC-SNAP

pppoe-vcmux

PPP over Ethernet, VC-muxed

pppoe-llc

PPP over Ethernet, LLC-SNAP