Motorola 2200 ユーザーズマニュアル

259

set igmp wireless-m2u [ on | off ]

This command allows you enable or disable wireless multicast-to-unicast if igmp snooping is set to on.

set igmp log-enable [ on | off ]

If set to

on, all IGMP messages on both the LAN and the WAN will be logged. Default is off.

IP Settings

You can use the command line inter face to specify whether TCP/IP is enabled, identify a default Gateway,
and to enter TCP/IP settings for the Motorola Netopia® Gateway LAN and WAN por ts.

☛

NOTE:

For the DSL platform you must identify the vir tual PPP inter face [

vccn], a number from 1 to 8.

Common Settings

set ip option { on | off }

Enables or disables TCP/IP ser vices in the Motorola Netopia® Gateway. You must enable TCP/IP ser vices
before you can enter other TCP/IP settings for the Motorola Netopia® Gateway. If you turn off TCP/IP ser-
vices and save the new configuration, the Motorola Netopia® Gateway clears its TCP/IP settings.

ARP Timeout Settings

set ip arp-timeout [ 60 ... 6000 ]

Sets the timeout value for ARP timeout. Default = 600 secs (10 mins); range = 60 secs - 6000 secs (1–
100 mins).

DSL Settings

set ip dsl vccn address

ip_address

Assigns an IP address to the vir tual circuit. Enter 0.0.0.0 if you want the vir tual circuit to obtain its IP
address from a remote DHCP ser ver.

set ip dsl vccn broadcast

broadcast_address

Specifies the broadcast address for the TCP/IP network connected to the vir tual circuit. IP hosts use the
broadcast address to send messages to ever y host on your network simultaneously.

The broadcast address for most networks is the network number followed by 255. For example, the broad-
cast address for the 192.168.1.0 network would be 192.168.1.255.