Mitsubishi Electronics M700V ユーザーズマニュアル

E70 Series Connection Manual

4.2 Connection of Control Unit

4.2.8 Connecting with Synchronous Feed Encoder/ Manual Pulse Generator

Synchronous feed encoder (1ch) or 5V power supply type manual pulse generator (2ch) can be connected.

<Related items>

Cable drawing: "Cable: FCUA-R050/R054 Cable" and "Cable: G023/G024 Cable"

Connector pin assignment: "General Specifications: Control Unit" (ENC connector)

When using the synchronous feed encoder and the manual pulse generator at the same time, the cables must be

prepared by the machine tool builder.

4.2.8.1 Handle Numbers

Unit configuration decides handle Nos.

"ENC": Connector on control unit "MPG": Connector on operation panel I/O unit

(Note)

If one handle is only connected to "MPG", the handle connected to "ENC" 1ch will still be treated as the 3rd

handle. "ENC" 2ch is not employed when an operation panel I/O unit is used.

Operation panel I/O unit (FCU7-DX71x/ DX72x/ DX73x/DX621)

1st handle

2nd handle

3rd handle

Used

"MPG" 1ch

"MPG" 2ch

"ENC" 1ch (Note)

Not used

"ENC" 1ch

"ENC" 2ch

5V 0V A B

NO.1

NO.2

NO.1

5V 0V A B

OSE1024-3-15-68

ENC

G023 cable

5V manual pulse generator

(Rear view)

G024 cable

When connecting one 5V
manual pulse generator

When connecting two 5V
manual pulse generators

R050 cable

R054 cable

Synchronous feed encoder

5V manual pulse generator

(Rear view)