Eureka! Tents 4 ユーザーズマニュアル

NOTE: Do not drop tent bag or pole bag on its end. Do not bounce tent bag on 

1. Unpack the tent bag and separate the components. Unfold the tent 

and lay it out with the floor on the ground and with a grommeted web 

in each corner.  Pull the tent into a rough rectangle. Do not stake down 

the tent just yet; but in windy conditions, stake down one corner that 

faces into the wind.

2. Assemble the three shockcorded tent poles. Carefully seat each 

section. Try to keep the poles from snapping together as this can 

damage the rod ends.

3. At the front of the tent body at A, slide a pole diagonally across the 

tent, through the sleeves, to the  opposite side B. Follow the seam 

from sleeve to sleeve. Push the pole, don't pull it. Continue with the 

second pole through its sleeves from C to D.  Finish with the third pole 

from E to F.  See fig.1.        

4. Insert the post end of a pole into its grommet on the corner 

stake-out web. See fig.2. At the opposite corner, grasp the web 

and simultaneously push the pole to form an arc. Insert the post 

into the grommet to maintain tension. See fig.3.Repeat with the 

remaining  poles, raising the tent. See fig.4. 

5. Your tent is now free-standing; place it in the desired location 

and use the metal skewers to stake it down.

6. With the tent secure, unroll the fly and drape it over the tent. 

The fly only fits one way; make sure the vestibule panel 

window is directly over the front door of the tent. Reach under 

the fly and connect the Velcro®  fasteners to the tent poles, 

through the openings in the sleeves.  See figs.5 & 6.

7. Connect the six 

side-release buckles on the 

fly to their mates on the tent 

webs. See fig.7. 

8. At the rear of the tent, stake 

down the pull-out web on 

the fly. 

9. At the front of the tent, pull the vestibule taut and stake it 

down. Make sure that the vestibule is tight across the door flap.  

With the vestibule staked down and tight, go to the corners / 

sides of the tent and adjust the web pull-outs to tighten. Then if 

necessary, adjust the rear vestibule stake out loop. See Fig.8.

                        

NOTE: 
• The vestibule door of the fly can be rolled up at the bottom, 

up to the top or to the side for better ventilation. Attach the 

toggle to hold in place. To help prevent condensation, keep 

the doors open. 

•  In strong winds, tie extra ropes to the storm loops on the fly 

and stake down.

• Take down :  Pull up stakes. Release the fly's Velcro® and 

buckles. Remove fly and open door. Pull posts out of the 

grommets and push poles out of the sleeves. Collapse the 

tent poles and stow.  Fold the tent onto itself and fold the fly 

and lay it on tent. Roll up both towards the door and stow.

REV.C 4.09

Fig.1

Fig.2

Fig.3

Fig4

Fig.5

Fig.6

Fig.7

Fig.8