Uniden 880 ユーザーズマニュアル

8

Because the maximum power output of the transmitter is limited by 

the FCC, the quality of your antenna is very important. To achieve the 

maximum transmission distance, Uniden strongly recommends that you 

install only a high quality antenna. You have just purchased a superior 

transceiver - don't diminish its performance by installing an inferior 

antenna. 

Only a properly matched antenna system will allow maximum power 

transfer from the 50 ohm transmission line to the radiating element. 

Your Uniden dealer is qualified to help you select the proper antenna for 

your requirements. A whip style antenna may be used for automobile 

installation. 

A short ‘loaded’ whip antenna is easier to install on an automobile, but its 

efficiency is less than that of a full quarter-wave whip antenna. 

Uniden recommends connecting the power lead to the Ignition Switch 

Accessory Terminal. This way, the transceiver is automatically turned off 

when the ignition switch is turned off. 

As an alternative, the power cord may be connected to an available 

terminal on the fuse block or to a point in the wiring harness. However, 

caution must be taken to prevent a short circuit. If in doubt, contact your 

vehicle dealer for information. 

With a negative ground system, the negative (-) battery terminal is 

usually connected to the vehicle motor block.  

Connect the red DC power cord from the 

transceiver to the positive (+) battery terminal