Transition Networks E-100BTX-FRL-01(SM) ユーザーズマニュアル
The TRANSITION Networks Ethernet™ 100BASE-TX to 100BASE-FX media
converters connect 100BASE-TX unshielded twisted pair cable to 100BASE-FX
multimode or singlemode fiber-optic cable. Media converter models are selected
according to the fiber mode and fiber connector required at the site. Multimode
fiber-optic cable can use either an ST connector (E-100BTX-FRL-01) or an SC
connector (E-100BTX-FRL-01(SC)). Singlemode fiber (E-100BTX-FRL-01(SM)) uses
only an SC connector. All media converters function in half-duplex mode or, when
connected to devices capable of full-duplex connectivity, in full-duplex mode.
converters connect 100BASE-TX unshielded twisted pair cable to 100BASE-FX
multimode or singlemode fiber-optic cable. Media converter models are selected
according to the fiber mode and fiber connector required at the site. Multimode
fiber-optic cable can use either an ST connector (E-100BTX-FRL-01) or an SC
connector (E-100BTX-FRL-01(SC)). Singlemode fiber (E-100BTX-FRL-01(SM)) uses
only an SC connector. All media converters function in half-duplex mode or, when
connected to devices capable of full-duplex connectivity, in full-duplex mode.
Minneapolis, MN 55344 USA
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Compliance Information
UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
C-UL Listed (Canada)
CISPR/EN55022 Class A
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
the radio interference regulations of the Canadian Department of Communications.
European Regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Copyright Restrictions
© 1996, 1997 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
33009.C
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
MEDIA CONVERTER TECHNICAL SPECIFICATIONS
Standards
IEEE 802.3
Case dimensions
3.9" x 3.0" x 1.0"
(99mm x 76mm x 25mm)
Environment
Temperature:
0-40°C (32° to 104° F )
Humidity
10-90%, non condensing
Altitude
0-10,000 feet
Warranty
Five years
100BASE-TX/100BASE-FX
Media Converters
E-100BTX-FRL-01, E-100BTX-FRL-01(SC), E-100BTX-FRL-01(SM)
USER’S GUIDE
Pwr
(Power) Illuminated green LED
indicates connection to external
AC power.
indicates connection to external
AC power.
RX
(Receive) Flashing green LED
indicates port is receiving
data.
indicates port is receiving
data.
Link
Steady green LED indicates port is
receiving link signal.
receiving link signal.
UTP
E-100BTX-FRL-01
Multimode Fiber
UTP
E-100BTX-FRL-01(SC)
Multimode Fiber
UTP
Singlemode Fiber
(SM)
E-100BTX-FRL-01(SM)
Status LEDs on the connector side of the media
converters provide the following information:
converters provide the following information:
10BASE-T
ST Connectors
RX
TX
Link
RX
Link
RX
Pwr
(Fiber)
Link
RX
RJ-45 Connector
10BASE-T
10BASE-FL
SC Connectors
RX
TX
Link
RX
Link
RX
Pwr
RJ-45 Connector
10BASE-T
10BASE-FL
Pwr
RX
Link
(RJ-45)
Power Supply Requirements
Replace power supply with only the equivalent input
rating (see below) and output rating (regulated 9VDC at 0.5 A).
TN PN
Requirement
Location
3517
240 volts, 50 hertz
United Kingdom
3516
230 volts, 50 hertz
Europe
3518
120 volts, 60 hertz
USA/Canada/Mexico
3514
100 volts, 50-60 hertz
Japan
3515
240 volts, 50 hertz
Australia
E-100BTX-FRL-01
Provides an RJ-45 unshielded twisted
pair 100BASE-TX connector and a set
of RX (receive) and TX (transmit) ST
100BASE-FX connectors to multimode
fiber-optic cable.
pair 100BASE-TX connector and a set
of RX (receive) and TX (transmit) ST
100BASE-FX connectors to multimode
fiber-optic cable.
E-100BTX-FRL-01(SC)
Provides an RJ-45 unshielded twisted
pair 100BASE-TX connector and an
RX (receive) and TX (transmit) SC
100BASE-FX connector to multimode
fiber-optic cable.
pair 100BASE-TX connector and an
RX (receive) and TX (transmit) SC
100BASE-FX connector to multimode
fiber-optic cable.
E-100BTX-FRL-01(SM)
Provides an RJ-45 unshielded twisted
pair 100BASE-TX connector and an
RX (receive) and TX (transmit) SC
100BASE-FX connector to singlemode
fiber-optic cable.
pair 100BASE-TX connector and an
RX (receive) and TX (transmit) SC
100BASE-FX connector to singlemode
fiber-optic cable.