Multiquip SG1400C3-55748 ユーザーズマニュアル

ページ / 116
Sg1400C3 STudio generaTor • operaTion and parTS manual — rev. #1 (02/15/12) — page 25
CaMLOk/vOLtaGE OutPut PanEL
The definitions below describe the controls and functions 
of the Camlok/Voltage Output Panel (Figure 7).
1. 
CB4/CB5 Circuit Breakers — These circuit breakers 
protect the 120 VAC auxiliary output receptacles from 
overload. 
2. 
CB6/CB7 Circuit Breakers — These  circuit breakers 
protect the bates output receptacles from overload. 
3. 
generator voltage Test points  — To  determine  if 
the generator's output voltage is present and correct, 
connect  a  test  meter  to  these  test  points  during 
troubleshooting and maintenance.
4. 
paralleling Cable in — This Ethernet input connection 
point is used when multiple generators are going to be 
connected.
5. 
paralleling  Cable  out  — This  Ethernet  output 
connection point is used when multiple generators are 
going to be connected.
6. 
BuS Hot indicator lamp — When lit, this indicator 
lamp  informs  that  the  voltage  bus  is  active  (high 
voltage). 
never connect or disconnect cables from 
the camlok or auxiliary receptacles when this indicator 
is 
on. The possibility exists of electrocution, shock or 
even death if cables are connected or unplugged when 
this indicator is lamp lit.
7. 
120 vaC  output  receptacles  — These  15-amp 
receptacles provide 120 VAC output. The maximum 
allowable combined amps (both receptacles) is 25 amps 
when the voltage selector switch in the 3
Ø
 277/480 VAC 
position.
8. 
Bates  120vaC  output  receptacles  —  These 
receptacles provide AC voltage output. Each receptacle 
is protect by a 100 amp breaker. These receptacles 
cannot be used when the voltage selector switch is in 
the 3
Ø
 277/480 VAC position.
9. 
Camlok  receptacles  — These  output  voltage 
connection points (6 pairs) are used for load connection. 
alWaYS pay close attention when connecting and 
disconnecting  power  cables  from  these  camlok 
receptacles. The  possibility  exists  of  electrocution, 
shock  or  even  death  if  cables  are  connected  or 
unplugged when the bus hot indicator lamp is lit.
3
4
5
6
7
7
8
8
GREEN
WHITE
RED
BLUE
BLACK
9
1 2
Figure 7. Camlok/Voltage Output Panel