DLO DLZ62000 ユーザーズマニュアル

| 11

10 |

DLO TUNESTIK USER MANUAL

Tuning Your TuneStik

Press the Frequency Button on the TuneStik Control. The red light on the top of the

remote will flash, and your iPod will display “Ok to disconnect” followed by “CH 1

88.5” (the default broadcast frequency for your TuneStik). This places the TuneStik

Control in

Frequency Mode

You are now able to change the frequency of your TuneStik to match the station on

your car stereo. To do this, simply press the

Frequency Button

to enter

Frequency

Mode

and tune up or down using the TuneStik Control’s

+/- Buttons

. Your iPod will

display the frequency to which your TuneStik is broadcasting.

NOTE:

Your TuneStik Control will allow you to tune the FM Transmitter in

Frequency Mode

as long as you need to before reverting back to

Primary Mode

after 10 seconds of inactivity.

Setting a Preset Frequency

You can set up to 4 preset stations when you find frequencies that work well in your

area. When you’ve found the station you’d like to keep, tune your TuneStik’s fre-

quency to that station (displayed on your iPod after you’ve pressed the

Frequency

Button

). Next, press the

Play/Pause Button

to set your preset and exit

Frequency

Mode

, or simply leave the TuneStik on that particular frequency (after a few sec-

onds, your TuneStik Control will revert to

Primary Mode

To set another preset, press the

Frequency Button

twice to get to the next open chan-

nel on your TuneStik, then tune to the desired frequency using the

+/- Buttons

. Press

the

Play/Pause Button

to exit

Frequency Mode

, or simply wait to set this frequency as

your new preset. Repeat this process for up to four total presets.

You can also turn the FM transmitter completely off by cycling past all 4 presets to the

OFF Setting. Then press the

Play/Pause Button

or wait a few moments to apply. To

turn the FM Transmitter back on, repeat these steps but stop at a Preset instead.

Switching between Monaural and Stereo Mode

With the DLO TuneStik you have the choice of transmitting in either Monaural or

Stereo Mode. Choose between the two based on what type of audio you’re playing and

what sounds best to your ears.

Monaural Mode allows for much better transmitter performance and is also useful for

listening to audiobooks and most podcasts. Use Stereo Mode when you have a clear

empty signal to broadcast to, and for best sonic musical performance. If the static

increases or you move to a crowded FM radio area, try Monaural Mode for the

strongest Transmitter signal strength possible.

To switch between Monaural Mode and Stereo Mode press the

Frequency Button

, then

press the

Backlight Button

to toggle between Monaural Mode and Stereo Mode. Your

iPod will display

to indicate Monaural Mode and

to indicate Stereo Mode.