Vocopro GIG-STAR ユーザーズマニュアル
Speaker Connection
The GIG STAR has a set of speaker connectors for connection to external speakers. Remember that only
speakers with an impedance rating of 8 ohms should be connected.
speakers with an impedance rating of 8 ohms should be connected.
To connect speakers:
1. Unlock the plastic fasteners on each speaker connector by pushing downward on them.
2. Strip approximately a 1 /2” (1.27cm) of insulation from the speaker wire ends and twist the strands so that they
can easily slide through the holes.
3. Once a wire is inserted, lock them in place with the fasteners by pushing upward on them.
NOTE: It is easy to over-insert a wire into a speaker connector so that the insulation is inserted as well. To ensure this doesn’t happen, only
insert the wires to the point where you can still see the edge of the insulation.
1. Unlock the plastic fasteners on each speaker connector by pushing downward on them.
2. Strip approximately a 1 /2” (1.27cm) of insulation from the speaker wire ends and twist the strands so that they
can easily slide through the holes.
3. Once a wire is inserted, lock them in place with the fasteners by pushing upward on them.
NOTE: It is easy to over-insert a wire into a speaker connector so that the insulation is inserted as well. To ensure this doesn’t happen, only
insert the wires to the point where you can still see the edge of the insulation.
AM/FM Antenna Connection
Connecting the FM Antenna to the GIG STAR
The FM antenna looks like a thin wire with a gray plastic plug at one end. To connect the FM antenna to the GIG STAR, insert the gray plug into
the FM antenna receptacle.
the FM antenna receptacle.
Connecting the AM Antenna to the GIG STAR
The AM antenna has a braided wire connected to a large oval shaped loop antenna. The opposite end has two exposed copper-colored wires.
To connect this antenna:
1. Press down the tabs on the AM antenna receptacle on the back of the GIG STAR.
2. Insert the copper-colored wires into each side of the receptacle.
3. Release the tabs to secure the wires in place.
Note: Please ensure that the wire ends to be inserted into the AM Antenna receptacle are stripped of insulation at least a 1/2 inch.
1. Press down the tabs on the AM antenna receptacle on the back of the GIG STAR.
2. Insert the copper-colored wires into each side of the receptacle.
3. Release the tabs to secure the wires in place.
Note: Please ensure that the wire ends to be inserted into the AM Antenna receptacle are stripped of insulation at least a 1/2 inch.
Getting Connected
4
*Set to EXT for
External Speaker
Output
L
R
SPEAKER 8
INT
EXT
Speacker Selector