Tyco Electronics M7300 Series ユーザーズマニュアル
MM-014716-001
83
3. While current scan status is displayed, press (
+) to add the channel to the scan list. is displayed.
This sets the selected channel for non-priority scanning.
4. Press (
+) again to set the channel for Priority 2 (P2) scanning and is displayed.
5. A third press of (
+) sets the channel for Priority 1 (P1) scanning and is displayed on line 1. If the
P1 or P2 channels are already set and a new channel is then assigned as the P1 or P2 channel, the
previously assigned priority channel will change to non-priority scanning. The priority setting
selection sequence is set and stops at P1, therefore the channel must be deleted from the scan list by
previously assigned priority channel will change to non-priority scanning. The priority setting
selection sequence is set and stops at P1, therefore the channel must be deleted from the scan list by
pressing (
-) before the channel is set to a previous priority setting. Any channel that is in a system's
channel scan list will show
,
, or
when it is the selected channel.
10.8.2 Deleting Channels from a Scan List
1. With scan operation turned OFF select the desired channel to delete from the selected conventional
system's channel scan list.
2. Press (
+) or (-) with
. The current status is displayed for a time-out period. Press (
-) to delete
the channel from the scan list.
,
, or
will turn OFF.
10.8.3 Nuisance Delete
A channel can also be deleted from the scan list, if it is not the currently selected channel, by pressing (
-)
twice during scan operation while the radio is displaying the unwanted channel. The channel will be
deleted from the conventional system's channel scan list in the same manner as if done using the steps
above. Deletions done in this manner will not remain deleted if the radio is turned OFF and then back
ON.
deleted from the conventional system's channel scan list in the same manner as if done using the steps
above. Deletions done in this manner will not remain deleted if the radio is turned OFF and then back
ON.
10.9 TURNING SCAN ON
1. Toggle the scan operation ON by pressing SCAN. The
SCAN indicator will turn ON when the radio
is scanning.
Scanning will stop while the microphone is off-hook if the hookswitch feature is enabled
through programming.
through programming.
2. When a channel on the scan list receives a channel assignment, the radio unmutes on the assigned
channel, BSY indicator comes ON and the received scan channel is displayed.
•
The radio will continue scanning if a new channel is selected when scan is ON.
•
Pressing the PTT button when scan is ON will cause the radio to transmit on the displayed
channel or to the currently selected channel depending on programming.
channel or to the currently selected channel depending on programming.
•
Pressing (
+) with
when scan is ON causes the radio to recall the scanned channel that
was last received. This channel is recalled for a period equal to the scan hang time.