Tyco Electronics M7100IP ユーザーズマニュアル
56
3. If the
c key is pressed before the time-out, the squelch level will not be updated and the
original value will be restored.
13.8
TYPE 99 DECODE
If the Type 99 Decode Option has been pre-programmed, individual selective calling is possible. The radio
can now decode individual, group or supergroup paging calls. Two sets of Type 99 paging codes must be
pre-programmed into the radio. When the radio decodes an appropriate Type 99 code sequence, an alert
tone and visual indicator is provided to the user. The receiver then operates as a noise squelched unit until
Type 99 is reset. Type 99 decode continues to operate during this noise squelched period. The appropriate
Type 99 alert tone will sound again if it detects a valid two-tone sequence.
can now decode individual, group or supergroup paging calls. Two sets of Type 99 paging codes must be
pre-programmed into the radio. When the radio decodes an appropriate Type 99 code sequence, an alert
tone and visual indicator is provided to the user. The receiver then operates as a noise squelched unit until
Type 99 is reset. Type 99 decode continues to operate during this noise squelched period. The appropriate
Type 99 alert tone will sound again if it detects a valid two-tone sequence.
Type 99 operation can be reset manually or automatically (pre-programmed). Manual reset is achieved by
briefly pressing
c, if programmed. Automatic reset, if enabled, occurs after a 30 second interval
following the most recent decode of a Type 99 tone sequence. Hookswitch (pre-programmed) can also
enable or disable Type 99 decode. The pre-programmed key light will blink when Type 99 is disabled by
the hookswitch.
enable or disable Type 99 decode. The pre-programmed key light will blink when Type 99 is disabled by
the hookswitch.
Type 99 decode will continue to be active while the radio's
c button is pressed. This allows the user to
monitor calls and still be alerted when a call is directed to the user. While the user continues to press
c,
the user will hear both calls and all Type 99 tone signals. If
c is pressed for longer than two (2)
seconds, Type 99 decode will either be disabled or re-enabled depending upon its present state.
To check the Type 99 enable status, press the Scan Add/Delete
< or >. The current status of Type 99
decode will be displayed for a time-out period. Type 99 is enabled when the letter T is displayed in the
third segment from right on the first line of the LCD.
third segment from right on the first line of the LCD.
If a Horn Alert Option is installed and enabled with the Type 99 Decode Option, the radio can beep the
vehicle horn when a Type 99 call is received. This option permits alerting persons out of the vehicle when
a call is received.
vehicle horn when a Type 99 call is received. This option permits alerting persons out of the vehicle when
a call is received.
Type 99 is automatically disabled when Scan is enabled.
13.8.1
Menu Selection
Press
M and then use . or , controls to scroll through the selections until T99 ENAB
is displayed. Then press
M to toggle the Type 99 decode state. The T99 ON or T99 OFF
display message is displayed for two seconds to show the new state.
13.8.2
Pre-Programmed Keypad Key
Press the pre-programmed key and the T99 ON or T99 OFF display message is displayed for two
seconds to show the new state.
seconds to show the new state.