Martin Audio DX2 ユーザーズマニュアル

ページ / 116
All material © 2007. Martin Audio Ltd. Subject to change without notice. 
 
Loading binary presets into your Martin Audio DX2 
Loudspeaker Management System 
 
 
 
 
  
Clicking 
containing the loader software and binary files. 
Extract these to your hard disk. Do not run the programme from the zip folder. 
 
Warnings 
Loading presets will overwrite previously loaded factory presets - and any 
changes to them (e.g. channel gain, delay, limiter settings). 
 
To make a permanent record of changes to the user-editable parts of a preset, 
you must save the preset in one of the lower number memory locations. 
 
Make sure you have a full set of .bin files before proceeding so that you can 
reload your original presets if you need to. 
 
If you are not familiar with the Martin Audio DX2, please read the DX2 
User Guide. 
 
 
You should have extracted the following files to a suitable folder on your 
hard drive:
 
 
  MartinFlashLoader.exe – The DX2 binary preset loader software 
 
  MARTN1RLCDLC21801.bin – Binary presets for 
W8LCD+W8LC+WS218X/W8LS combinations 
 
  MARTN1RLCDLCWLX01.bin – Binary presets for W8LCD+W8LC+WLX 
combinations 
 
  MARTN1RLDLBLS02.bin – Binary presets for W8LD+W8L 
Longbow+W8LS/WS218X combinations 
 
  MARTN1RLM218X03.bin – Binary presets for 
W8LMD/LM+WS218S/W8LS combinations 
 
  MARTN1RLMWLX03.bin – Binary presets for W8LMD/LM+WLX 
combinations 
 
  MARTN1RLMWMX03.bin – Binary presets for W8LMD/LM+WMX 
combinations 
 
  MARTN1RLE12152101.bin – Binary presets for 4-mix LE1200, LE1500 
or LE2100 systems