Roberts Radio DreamTime2 ユーザーズマニュアル

1.  Place your clock radio on a fl at surface. 

2.  Fully extend the wire aerial located on the rear of your clock radio. 

Place the wire antenna so that it is as straight as possible extending 
either above or below the radio.

 
3.  Insert the adaptor plug into the DC socket located on the rear of your 

clock radio. Plug the adaptor into a standard 13 amp mains socket 
outlet. The display will show 'ROBERTS' for a few seconds and will 
then show 'SET CLOCK'. During this time the radio is scanning to fi nd 
a DAB radio signal. After a short time the current time and day will 
appear on the display. 

4.  If no signal is  found, 'NO CLOCK' will be displayed. It may be necessary 

to relocate your clock radio to a position giving better reception. You 
should then carry out a scan to fi nd stations as described on page 9.

IMPORTANT:  The mains adaptor is used as the means of connecting 
the clock radio to the mains supply. The mains socket used for the clock 
radio must remain accessible during normal use. In order to disconnect 
the clock radio from the mains completely, the mains adaptor should be 
removed from the mains socket outlet completely.

Characters appearing on the LCD display indicate that the clock radio is 
connected to and powered from the mains supply.

DC 7.5V