Motorola 438-470 MHz ユーザーズマニュアル

6880904Z07-O

August, 1996

Foreword

GP350 Portable Radios Service Manual

Radio Service Software Information

To run the Radio Service Software, you will need the following equipment:

1.

Connect the RIB to the computer (Figure 2).

2.

If your computer has an XT style communications port (25 pin connector), plug the HLN9390 adapter into the com-
puter and plug the HKN9216 cable into the adapter. If you are unsure of which connection is on the back of your
computer or the COM port, then please consult the computer manuals.

3.

Plug the large 25 pin end of the HKN programming cable into the RIB. The other end of this cable has a “battery
eliminator.”

4.

Connect the two adapter plates (REX1143) to HKN9857 according to the instructions supplied with the Programming
Hardware Kit.

5.

Slide the battery eliminator in place of the radio’s battery.

6.

Plug the HSN9412 power supply into a wall outlet, and connect the other end to the RIB.

7.

Connect the radio to a power supply and turn the volume control clockwise to turn it on.

Required Equipment:
1.

TM

 with 512K RAM, Dual Floppy Disk Drives or on Floppy Disk

and one Hard Disk.

2.

TM

 or MSDOS

TM

 3.0 or later.

3.

Radio Interface Box (RIB) HLN9214.

4.

RIB to IBM AT cable HKN9216.

5.

IBM AT cable to IBM XT computer adapter (optional) HLN9390.

6.

Programming/Test cable (HKN9857).

7.

Programming Hardware Kit (REX1143).

8.

RIB power supply HSN9412 (110 VAC) or 0180358A56 (220 VAC).

9.

Power Supply R1011A or equivalent.

  

Power Supply (7.2 VDC)
Note: Battery can be used on 
programming cable making 
power supply optional.

HSN9412
RIB Power Supply.
Plug into 110 VAC 
outlet

 

Plugs  between  the  RIB  and  radio.

Plugs into RIB and
computer.