Motorola HT 1000 ユーザーズマニュアル
10
clockwise. The loudness of tone beeps will
increase and decrease accordingly.
increase and decrease accordingly.
NOTE:
During test mode, the volume level is not
regulated to the same limits as during normal
radio operation.
regulated to the same limits as during normal
radio operation.
To exit test mode, turn the radio off then back on.
RF Test Mode, MT 2000,
MTS 2000, and MTX
Series Radios
MTS 2000, and MTX
Series Radios
When the MT 2000, MTS 2000, or MTX series radio is operating in its
normal environment, the radio’s microcomputer controls the RF
channel selection, transmitter key-up, and receiver muting. However,
when the unit is on the bench for testing, alignment, or repair, it is
removed from its normal environment. It cannot receive commands
from its system and, therefore, the internal microcomputer will not
key the transmitter nor unmute the receiver. This prevents the use of
normal tune-up procedures. To solve this problem a special routine,
called TEST MODE or “air test,” has been incorporated in the radio.
normal environment, the radio’s microcomputer controls the RF
channel selection, transmitter key-up, and receiver muting. However,
when the unit is on the bench for testing, alignment, or repair, it is
removed from its normal environment. It cannot receive commands
from its system and, therefore, the internal microcomputer will not
key the transmitter nor unmute the receiver. This prevents the use of
normal tune-up procedures. To solve this problem a special routine,
called TEST MODE or “air test,” has been incorporated in the radio.
To enter test mode:
1. Turn the radio on.
2. After the self test is complete, press the monitor button (side
button 3, SB3) five times in succession, within 10 seconds.
3. After “RF TEST” appears (on 14-character displays) or “RF TST”
appears (on 6-character displays), press the orange button on top
of the radio once. “1 CSQ” appears, indicating: test frequency 1,
carrier squelch mode.
of the radio once. “1 CSQ” appears, indicating: test frequency 1,
carrier squelch mode.
4. Each additional press of SB3 will advance to the next test channel.
5. Pressing SB2 will scroll through and access test environments as
shown in Table 7.
NOTE:
Transmit into a load when keying a radio
under test.
under test.
NOTE:
Radios without display indicate test-
environment function by emitting a
corresponding number of beeps. See Table 7.
environment function by emitting a
corresponding number of beeps. See Table 7.
Control Head Test Mode,
MT 2000, MTS 2000,
and MTX Series Radios
MT 2000, MTS 2000,
and MTX Series Radios
To check the display, the buttons, and the switches, perform the
following tests:
following tests:
1. Turn radio on.
2. After the self test is complete, press the monitor button (side
button 3, SB3) five times in succession, within 10 seconds.
3. After ”RF TEST” appears on the display, press side button 1 (SB1),
“CH TEST” (14-character radio) or “CH TST” (6-character radio)
appears on the display.
appears on the display.
4. Next, press and hold the orange button on top of the radio; all
segments on the display will light, and the LED on the control top
will illuminate a yellowish color.
will illuminate a yellowish color.