Motorola HT 1000 ユーザーズマニュアル

32

6. Disconnect the front cover display flex from the connector on the 

chassis.

A special locking connector secures the flex to 
the chassis (see Figure 7).

a. Use the flex connector opening tool, large curved end 

(Motorola part no. 6680334E08), or like instrument to help 
raise the sliding portion of the connector approximately 1/8 
of an inch from its seated position. A slight prying action will 
achieve the best results for unlocking the connector.

b. Remove the flex from the chassis connector.

7. Remove the contoured O-ring/antenna bushing seal from the 

chassis.

8. Disconnect the controls flex from the connector on the controller 

board by following the procedure in step 6a and 6b.

MAEPF-27016-O

Front Cover/
Display Flex

Front Cover

Assembly

Chassis

Assembly

MAEPF-22572-O

Front Cover/
Display Flex

Front Cover

Assembly

Chassis

Assembly

Unit with 
early Front Shield 

Unit with 
latest Front Shield 

Top Corner

Pry Here

Top Corner

Pry Here

Flex Locked

in Connector

Flex Released

From Connector

1/8”