Blomberg DV 17540 NBL00 ユーザーズマニュアル

8 - EN

A

•The clothes dryer (“appliance‘) installation 

must be performed by a qualified installer.

•Install the appliance according to the 

manufacturer’s instructions and local codes.

•Do not install a clothes dryer with flexible 

plastic venting materials. If flexible metal (foil 

type) duct is installed, it must be of a specific 

type identified by the ap pliance manufacturer 

as suitable for use with clothes dryers. Flexible 

venting materials are known to collapse, be 

easily crushed, and trap lint. These conditions 

will obstruct the clothes dryer’s airflow and 

increase the risk of fire.

• To reduce the risk of severe injury or death,           

follow all installation instructions.

Connect the appliance to a grounded outlet 

protected by a fuse or circuit breaker of 

suitable capacity.

If your receptacle is a 3-wire receptacle as 

shown below, you must obtain a 3-wire dryer 

cord. A dryer cord can usually be found at 

your local hardware supply, electrical supply or 

home center. Cord should have closed loop or 

upturned end wire terminating connectors.

A If the dryer is installed in a mobile home, 

recreational vehicles, new branch-circuit 

installations or in areas where local codes do 

not permit grounding, only a 4-wire power 

supply cord shall be used.

1. Make sure that the dryer is not plugged into 

any power outlet.

B

 DO NOT plug end of dryer power cord 

into a live receptacle before connecting dryer 

power cord to dryer terminals and closing 

junction/splitter box as described below.

B

 DO NOT repair old power supply cords. 

Power cord must be changed only by a 

qualified person. There is a risk of electric 

shock!

2. Remove the screw from the cover of the 

junction box located at the top rear of the 

dryer.

3. Remove the red, white and black wire from 

the terminal block.

4. Remove the green ground wire from the 

ground terminal.

5. Loosen the strain relief clamp holding the 

4-wire cable.

6. Thread the 4-wire cable out through the 

strain relief clamp.

7. Thread the new 3-wire dryer cord through 

the strain relief clamp.

8. Attach the power cord Ground conductor 

(the center wire) to the terminal labeled N. 

3- wire receptacle

( 10-30R)

Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT

 

4-wire receptacle  
(14 -30R) 
 

3-wire receptacle  
(10 -30R) 
 

If yo u have 3-wir e receptacle, like  
this , a 3-wire dryer cord  mu st be 
purc hased locall y. 

 

Dryer shipped with cord to fit this
type 4 -wire receptacle