Alliance Laundry Systems TMB795C ユーザーズマニュアル

M414905

42

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

The following steps outline the procedure for 

connecting the electrical service to the tumbler.

1. Install a circuit breaker as close to the tumbler as 

possible. If more than one tumbler is being 

installed, a disconnect switch or circuit breaker 

should be provided for each. This will make it 

possible to disconnect each tumbler for 

maintenance purposes. 

2. Connect the conduit-encased leads to the disconnect 

switch, or circuit breaker. Connect the wire leads 

to the appropriate labeled terminal on the terminal 

block. The ground wire must be connected to the 

ground connection as shown in Figure 21. 

3. Check the electrical service phase sequence 

(three phase only) as follows:

a. Energize the electrical service (on reversing 

tumblers, ensure nonreversing is selected) and 

momentarily start the tumbler. Check the 

direction of the cylinder rotation. If the 

cylinder rotates clockwise (viewed from the 

front), the phase sequence is correct. If the 

cylinder rotates counterclockwise, proceed 

with step b.
NOTE:When viewed from the front, the 

b. Disconnect and reverse any two service leads 

on the terminal block.