Alliance Laundry Systems TMB795C ユーザーズマニュアル

M414905

56

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

The airflow switch (located on the rear of tumbler, 

Figure 26) is set at the factory for proper operation. 

However, if there is a problem with the switch, it 

should be adjusted as follows:

•

Confirm exhaust duct and make-up air vents are 

properly sized and not obstructed. Refer to 

Make-Up Air and Venting sections.

•

Confirm lint screen is clean and access panels are 

in place.

•

Check operation of airflow switch and adjust as 

follows:

The airflow switch operation is controlled by the 

counterweight position in the shaft. Moving the 

counterweight either increases or decreases airflow 

switch sensitivity. The counterweight should be 

adjusted so the disc moves away from the cabinet 

when the lint panel is opened 1.5 inches (38.1 mm) with 

a full load. Adjust the airflow switch as follows:

1. Load the tumbler. This adjustment is much faster 

to make with one person opening lint panel in 

front and another adjusting the counterweight in 

the rear of tumbler.

2. Temporarily tape down the lint panel safety 

switch located behind the upper right corner of 

the lint panel.

3. Start the tumbler. Open the lint panel 1.5 inches 

(38.1 mm). The airflow disc should move away 

from the cabinet, opening the switch contacts and 

shutting off the heat system. This indicates 

proper operation and proper adjustment.

4. If switch is not opening as described in step 3, it 

should be adjusted so it is MORE sensitive. 

Depress the spring clip and move counterweight 

toward disc. Retest by opening lint panel and 

continue moving counterweight toward disc until 

switch operates as described in step 3.

5. If switch opens BEFORE lint panel is opened the 

proper distance, step 3, it should be adjusted so it 

is LESS sensitive. Depress the spring clip and 

move counterweight away from the disc. Retest 

by opening lint panel and continue moving 

counterweight away from disc until switch 

operates as described in step 3.

W674