Beko DRCT 70 W ユーザーズマニュアル

20

EN

Lint and fibres released from the laundry 

to the air during the drying cycle are 

collected in the “Fluff Filter”. 

C 

Such fibre and lint are generally 

formed during wearing and washing.

C 

Always clean the filter after each 

Drying process.

C 

You can clean the filter and filter area 

by vacuum cleaner.

For Filter cleaning;

1. Open the cover

2. Remove the fluff filter by pulling it up 

and open the filter.

3. Clean lint, fibre, and the fluff by hand or 

with a soft piece of cloth.

4. Close the filter and place it back into its 

seat. 

C 

Clogging may arise on the filter 

surface after using your machine for 

some time; if this occurs, wash the 

filter with water and dry it before using 

again.

The moisture in the damp laundry is taken 

from the laundry and condensed. Drain 

the water tank after each drying cycle or 

during drying when “Water tank” warning 

light turns on.

C

You can use the water in the water tank 

in your steam irons or air humidifiers.

A

 Condensed water is not drinkable!

A

 Never take out the water tank when 

the programme is running!

Water tank may be located in two 

different places as indicated below, 

depending on the model of your dryer.

-  Inside the drawer on the panel

-  Behind the kick plate cover

If you forget to drain the water tank, your 

dryer will stop during the following drying 

cycles when the water tank is full and the 

“Water tank” warning light will turn on. If 

this is the case, press the “Start/Pause/

Cancel” button to resume the drying 

cycle after draining the water tank.

To drain the water tank:

1. Carefully remove the water tank by 

opening the kick plate cover/pulling the 

drawer.

2. Drain the water by opening the water 

tank cover.

3. If there is lint accumulation in the water 

tank cover, clean it and press to close. 

4. Place the water tank back into 

position.

Hot and humid air in the condenser is 

cooled with the cold air from the room. 

Thus, the humid air circulating in your 

dryer is condensed and then pumped 

into the tank.

C

Clean the condenser after every 15 

drying cycles or once a month.

To clean the condenser:

1. If a drying process has been carried 

out, open the door of the product and 

wait until it cools down.

2. Unlock the 4 condenser locks after 

opening the kick plate.

3. Pull out the condenser.

4. Clean the condenser with pressurized 

water and wait until the water drains.

5. Replace the condenser with the side of 

it labelled with “Top” facing upwards. 

Lock the 4 condenser locks. 

6. Close the kick plate cover.

 Close properly and 

check the locking 

latchs?

.