Beko DRCT 70 W ユーザーズマニュアル

8

EN

Refer to the nearest Authorised Service 

Agent for installation of your product.

C Preparation of location and electrical 

installation for the product is under 

customer’s responsibility.

B

 Installation and electrical connections 

must be carried out by a qualified 

personnel.

A 

Prior to installation, visually check if 

the product has any defects on it. If 

so, do not have it installed. Damaged 

products will cause risks for your 

safety.

•  Install the product in an environment 

which has no risk of freezing and is in a 

stable and level position.

•  Operate your product in a well 

ventilated, dust-free environment.

•  Do not block the air ducts in front of 

and under the product with materials 

such as long pile rugs and cupboard 

plinths.

•  Do not place your product on a long 

pile rug or on similar surfaces.

•  Do not install the product behind a 

door with a lock, sliding door or a 

hinged door which can strike the 

product.

•  Once the product is installed, it should 

stay at the same place where its 

connections have been made. When 

installing the product, make sure 

that the rear wall of it does not touch 

anywhere (tap, socket, etc.) and also 

pay attention to install the product at a 

place where it will stay permanently.

B

Do not place the product on top of the 

power cable.

•Keep at least 1.5 cm distance to walls of 

other furniture.

In products equipped with a condenser 

unit the water accumulated during the 

drying cycle is collected in the water tank. 

You should drain the accumulated water 

after each washing cycle.

You can directly send the accumulated 

water out through the water drain hose 

supplied with the machine instead of 

periodically draining the water collected in 

the water tank.

Connection pipe to water drain is at the 

bottom rear of your machine. 

1. Remove the bracket and the rubber 

cap.

2. Attach the drain hose and replace the 

bracket to its position.

Important:

C

 There is no pump in the machine, so 

ensure that the hose is placed to allow 

a easy water flow. 

C

 The end of the hose should never be 

higher than the level of the water outlet 

on the machine. Otherwise, the “tank 

full” light of your machine will illuminate 

and stop the programme.

C

 If the dryer is mounted on the washing 

machine by means of a bracket, use of 

the water drain hose is recommended. 

The drain hose should be directed 

downwards as shown in the figure.

In order to ensure that your product 

operates more silently and vibration-

free, it must stand level and balanced on 

its feet. Front feet of your product can