Beko dc 1560 ユーザーズマニュアル

15 - EN

Lint and fibres released from the laundry to the 

air during the drying cycle are collected in the 

“Cover Filter”.

C

 Such fibre and lint are generally formed 

during wearing and washing.

C

 Always clean the filter after each drying 

process.

C

 You can clean the filter and filter area by 

vacuum cleaner.

To clean the filter:

1.  Open the loading door.

2.  Remove the cover filter by pulling it up and 

open the filter.

3.  Clean lint, fibre, and cotton raveling by 

hand or with a soft piece of cloth.

4.  Close the filter and place it back into its 

seat. 

C

Clogging may arise on the filter surface after 

using your machine for some time; if this 

occurs, wash the filter with water and dry it 

before using again.

There are humidity sensors in your dryer that 

detect whether the laundry is dry or not.

To clean the sensor:

1.  Open the loading door of the dryer.

2.  Allow the machine to cool down if drying 

has been carried out.

3.  Wipe the metal sensors with a soft cloth, 

dampened with vinegar and dry them.

C

 Clean metal sensors 4 times a year.

A

 Never use solvents, cleaning agents 

or similar substances when cleaning 

since these materials can cause fire and 

explosion! 

The moisture in the damp laundry is taken from 

the laundry and condensed. Drain the water 

tank after each drying cycle or during drying 

when “Water tank” warning light turns on.

C

You can use the water in the water tank in 

your steam irons or air humidifiers.

A

 Condensed water is not drinkable!

A

 Never take out the water tank when the 

programme is running!

Water tank may be located in two different 

places as indicated below, depending on the 

model of your dryer.

-  Inside the drawer on the panel

-  Behind the kick plate cover

If you forget to drain the water tank, your dryer 

will stop during the following drying cycles 

when the water tank is full and the “Water 

tank” warning light will turn on. If this is the 

case, press the “Start/Pause/Cancel” button to 

resume the drying cycle after draining the water 

tank.

To drain the water tank:

1.  Carefully remove the water tank by 

opening the kick plate cover/pulling the 

drawer.

2.  Drain the water by opening the water tank 

cover.

3.  If there is lint accumulation in the water 

tank cover, clean it and press to close. 

4.  Place the water tank into its seat.

Hot and humid air in the condenser is cooled 

with the cold air from the room. Thus, the 

humid air circulating in your dryer is condensed 

and then pumped into the tank.

C

Clean the condenser after every 15 drying 

cycles or once a month.

To clean the condenser:

1.  If a drying process has been carried out, 

open the door of the product and wait until 

it cools down.

2.  Unlock the 4 condenser locks after 

opening the kick plate.

3.  Pull out the condenser.