Beko DRVS 73S ユーザーズマニュアル

8

EN

Refer to the nearest Authorised Service 

Agent for installation of your product.

C

 Preparation of location and electrical 

installation for the product is under 

customer’s responsibility.

B

 Installation and electrical connections 

must be carried out by a qualified 

personnel.

A

 Prior to installation, visually check if 

the product has any defects on it. If 

so, do not have it installed. Damaged 

products will cause risks for your 

safety.

•  Install the product in an environment 

which has no risk of freezing and is in a 

stable and level position.

•  Operate your product in a well 

ventilated, dust-free environment.

•  Do not block the air ducts in front of 

and under the product with materials 

such as long pile rugs and cupboard 

plinths. 

•  Do not place your product on a long 

pile rug or on similar surfaces.

•  Do not install the product behind a 

door with a lock, sliding door or a 

hinged door which can strike the 

product.

•  Once the product is installed, it should 

stay at the same place where its 

connections have been made. When 

installing the product, make sure 

that the rear wall of it does not touch 

anywhere (tap, socket, etc.) and also 

pay attention to install the product at a 

place where it will stay permanently.

B

Do not place the product on top of the 

power cable.

•  Keep at least 1.5 cm distance to walls 

of other furniture.

•  Leave at least 3 cm of space between 

the side and rear walls of the machine 

and the walls of the counter/cupboard 

when installing your machine under a 

counter or in a cupboard. Never use 

the tumble dryer without top plate. 

Ventilation hose assures exhausting of the 

air from inside the machine.

Vented dryer has 1 air outlet.

Stainless sheet metal or aluminum pipes 

can be used instead of the hose. The 

diameter of the pipe to be used should 

be minimum 10 cm.

Maximum hose and pipe lengths are 

given in the table below.

Hose

Pipe

Maximum length

4 m

5 m

1 elbow 45°

-1.0 m

-0.3 m

1 elbow 90°

-1.8 m

-0.6 m

1 elbow 90° short

-2.7 m

1 wall passage

-2.0 m

-2.0 m

C  Each elbow and other passages 

should be subtracted from the above 

maximum length.

To connect a ventilation hose;

1.  Connect the air outlet hose to the 

hose spacer piece by turning it anti-

clockwise.

2.  Make the hose passages as shown 

below.

C  Exhaust of humid air from the dryer 

into the room is inconvenient. It may 

damage the walls and furniture in the 

room.

C  The ventilation hose can be routed 

outdoors via a window or it can be 

connected to an air outlet in the wall 

(see diagram below).

C  Air outlet hose must be extended 

directly to the outdoors. There must 

be a small number of elbows as not to 

hinder air ventilation.

C  To prevent water accumulation in the 

hose, make sure that it is not folded on 

the floor.