Beko DV 7220 X ユーザーズマニュアル

14 EN

Child-proof lock of the machine should not 

be active in order to perform these two 

operations. If the child-proof lock is active, 

deactivate it before performing these 

operations.

In order to add or remove laundry after the 

programme starts:

1.  Press the “Start/Pause/Cancel” button to 

switch the dryer to “Pause” mode. Drying 

process will stop.

2.  Open the door at “Pause” position and 

close it again after adding or taking out 

laundry.

3.  Press “Start/Pause/Cancel” button to start 

the programme.

C

Any laundry added after the drying process 

has started may cause the dried clothes in 

the machine intermingle with wet clothes 

and the result will be wet laundry after the 

drying process is over.

C

Laundry may be added or taken out 

as much as desired during a drying 

process, but this process will extend the 

programme duration and increase energy 

consumption since the drying will be 

interrupted continuously. Therefore, it is 

recommended to add laundry before the 

drying programme has started.

There is a child-proof lock to prevent any 

programme interruption due to the pressing 

of button while the programme is running. 

The loading door and all buttons except the 

“On/Off” button on the control panel are 

deactivated when the child-proof lock is active.

Press the “Start/Pause/Cancel” and “Cancel 

audio warning” buttons simultaneously for 3 

seconds to activate the child-press lock. 

To start a new programme after the 

programme is over or to interrupt the 

programme, the child-proof lock should be 

deactivated. Press the same buttons for 3 sec. 

again to deactivate the child-proof lock.

C

Child-proof lock is deactivated when the 

machine is restarted by pressing the On/

Off button.

C

Press the relevant buttons for 3 seconds 

to activate the child-proof lock. A long 

beep will be heard and the child-proof lock 

will be activated. A double beep will be 

heard if you press any button or turn the 

programme selection knob while the child-

proof lock is active. Press the buttons for 3 

seconds to deactivate the child-proof lock. 

Single beep will be heard and child-proof 

lock will be deactivated.

A

 A double beep will be heard if you turn 

the programme selection knob when the 

machine is running and the child-proof 

lock is active. If you deactivate the child-

proof lock without returning the program 

selection knob to its previous position, the 

programme will be terminated since the 

position of the programme selection knob 

is changed. The drying light turns on and 

the machine remains on hold until a new 

programme is selected and the “Start/

Pause/Cancel” button is pressed.

To cancel any selected programme:

Press “Start/Pause/Cancel” button for about 

3 seconds. The “Filter cleaning”, “Water tank” 

and “End/ Anti-creasing” warning lights will 

turn on at the end of this period for reminding 

purposes.

A

 As the inside of the dryer will be excessively 

hot when you cancel the programme while 

the dryer is running, activate the ventilation 

programme to cool it down.

The “End/Anti-creasing”, “Filter cleaning” and 

“Water tank” warning lights on the programme 

follow up indicator will turn on when the 

programme comes to an end. The door can be 

opened and the machine becomes ready for a 

second cycle.

Press “On/Off” button to turn off the dryer.

C

Final step of the drying cycle (cooling step) 

is performed without heat application in 

order to keep the items at a temperature 

that would not harm them.

C

A 2-hour anti creasing programme to 

prevent laundry from creasing will be 

activated if you do not take the laundry out 

after the programme has come to an end.

C

If you will not take the laundry out 

immediately, do not stop the dryer before 

the drying process is complete.

C

Clean the filter after each drying (please see, 

Filter cleaning).

C

Drain the water tank after each drying 

(please see, Water tank)