Sterling SCD 10 ユーザーズマニュアル
10 CFM Compressed Air Dryer Chapter 2: Functional Description
8 of 30
Chapter 2: Functional Description
2-1 Models Covered in This Manual
This manual provides instructions for installing and operating your 10 cfm compressed air
dryer.
dryer.
2-2 General
Description
Mini compressed air dryers are designed to generate heated, dehumidified air at carefully
controlled temperatures for use in plastic drying systems. Drying systems are sized to meet
specific requirements stated by the purchaser at the time of purchase.
controlled temperatures for use in plastic drying systems. Drying systems are sized to meet
specific requirements stated by the purchaser at the time of purchase.
Moisture removal from hygroscopic (moisture attracting) plastic pellets is an essential step in
the manufacture of high-quality plastic products. This dehumidifying dryer is used to
generate very low dew point air, heated to a controlled temperature for drying plastic pellets
and regrind.
the manufacture of high-quality plastic products. This dehumidifying dryer is used to
generate very low dew point air, heated to a controlled temperature for drying plastic pellets
and regrind.
Many variables were considered in the selection of your drying system, including type of
materials, residence time, throughput of the extruder or injection molding machine. Should
your operating environment change, the manufacturer can advise you on necessary equipment
and process time and temperature modifications required for your system.
materials, residence time, throughput of the extruder or injection molding machine. Should
your operating environment change, the manufacturer can advise you on necessary equipment
and process time and temperature modifications required for your system.
2-3 Typical
Features and Components
Electrical solenoid valve
Compressed air filter, regulator, and gauge
Drying temperature range of 120ºF to 400ºF
Display of process temperature set point and actual settings
Process thermocouple located in the process air stream just before the hopper inlet
Nema 1 control enclosure:
a. Fusing
b. Power On light
c. IEC process heater contactor
d. Solid state relay
e. Alarm light
f. High temperature safety system
g. Airflow detection system
2-4 Options
Options can tailor your dryer to meet the exact requirements of the drying task being
performed.
performed.
Floor-mount configuration
Membrane compressed air dryer for low dew point operation
220/1/50 operation
230/1/60 operation