Whirlpool W10678945D 使用とお手入れ

Clean lint screen after every load
The lint screen is located in the door opening of the dryer.  

A screen blocked by lint can increase drying time.

To clean:
1.  Pull the lint screen straight up and out. Press tab down 

and open lint screen. Roll lint off the screen with your 

fingers.

2. Push the lint screen firmly back into place.
IMPORTANT:

n

Do not run the dryer with the lint screen loose, 

damaged, blocked, or missing. Doing so can cause 

overheating and damage to both the dryer and fabrics.

As needed cleaning
Laundry detergent and fabric softener residue can build 

up on the lint screen. This buildup can cause longer 

drying times for your clothes, or cause the dryer to stop 

before your load is completely dry. The screen is probably 

clogged if lint falls off while the screen is in the dryer.
Clean the lint screen with a nylon brush every 6 months, 

or more frequently, if it becomes clogged due to a residue 

buildup.

To wash lint screen
1.  Roll lint off the screen with  

your fingers.

2.  Wet both sides of lint screen  

with hot water.

3.  Wet a nylon brush with hot water  

and liquid detergent. Scrub lint  

screen with the brush to remove  

residue buildup.

4.  Rinse screen with hot water.
5.  Thoroughly dry lint screen with  

a clean towel. Reinstall screen  

in dryer or lint filter.

Clean HybridCare™ filter after every 5 loads
The filter is located in bottom corner of dryer. The control

panel has an indicator light to remind you to clean the 

HybridCare™ filter.

1.  Open the bottom filter door. Lift handle up and pull out

filter. Set filter on the dryer and pull out lint screen and

foam pad located at the back of the filter. Remove lint

off the screen and foam pad with your fingers.

NOTE: If lint still remains  

on screen and foam pad  

then wet both sides with  

hot water. If necessary,  

wet a nylon brush with  

hot water and liquid  

detergent. Scrub lint  

screen with the brush  

to remove residue buildup.  

Rinse screen and foam pad  

with hot water.

2.  Clean the filter housing  

and mesh inside with a  

damp cloth, household  

vacuum cleaner, or soft  

brush. Clean the screen  

at the back of the filter  

cabinet once a month. 

3.  Put lint screen and foam  

pad back into filter and  

put filter back in dryer  

cabinet. Dryer will not  

operate without filter  

and make sure the  

handle is downward to 

lock in place. LF will  

display if not properly seated.

n

Do not run the dryer with the filter loose, damaged,

blocked, or missing. Doing so can cause overheating 

and damage to both the dryer and fabrics.