Haier CGDE700AW ユーザーズマニュアル

• Select a suitable location for the dryer on a hard even surface away from 

direct sunlight or heat sources, baseboard heaters, cooking appliances etc. 
Any floor unevenness should be corrected with leveling legs located on the 
bottom of the dryer.

•

Phillips head and flathead screwdrivers

•

Channel-lock adjustable pilers

•

1/2 inch open end wrench

•

Carpenter’s level

•

Measuring tape (12ft. min.)

•

Duct tap

•

Rigid or flexible metal 4 inch (102cm) duct

•

Vent hood

3 or 4 wire, 240 Volt, 30 Amp,60Hz, 1 Phase Power Supply Cord Kit (not 
supplied when sold in the United States) – Purchase to meet local electrical codes.

The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 Type
SPDT RATED AT 240 Volt AC minimum, 30 Amp., with 3 open end spade lug 
connectors with upturned ends or closed loop connectors and marked for use with
clothes dryers. If being installed in a manufactured (mobile) home,the dryer MUST
employ a 4-conductor power supply cord. NEMA 14-30 type SRDT or ST (as
required) rated at 240 Volt AC Minimum, 30 Amp., with 4 open end spade lug
connectors with upturned ends or closed loop connectors and marked for use with
clothes dryers. See Electrical Connections for A 4-Wire System.

Candian models are supplied with the appropriate power cord.

1. Remove all packaging material. This includes the foam base and all adhesive 

tape holding the dryer accessories inside and outside.

2. Inspect and remove any remains of packaging, tape or printed materials 

before using the dryer.