KitchenAid FRONT-LOADING GAS DRYER ユーザーズマニュアル

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.   

Remove parts packages from dryer drum. Check that all parts are 
included.

Remove the optional decorative mat (included) from the top of 
the dryer and set aside.

1. Insert the 2 screws through the holes in the door.

2. Place the plastic washers onto the screws.

3. Attach the handle by hand tightening the screws, first the top 

then the bottom.

4. Push the handle against the door. Using a Phillips 

screwdriver, tighten the screws. 

NOTE: Do not overtighten.

Check local codes and with gas supplier. Check existing gas 
supply, electrical supply and venting. Read “Electrical 
Requirements,” “Gas Supply Requirements” and “Venting 
Requirements” before purchasing parts.

■

For close-clearance installations between 33" (83.8 cm) and 
38" (96.5 cm), see “Plan Vent System” section for venting 
requirements.

Mobile home installations require metal exhaust system hardware 
available for purchase from the dealer from whom you purchased 
your dryer. For further information, please refer to the “Assistance 
or Service” section of this manual.

■

Mobile Home Installation Kit. Ask for Part Number 346764.

■

Metal exhaust system hardware.

Are you placing the dryer on a pedestal? You may purchase a 
pedestal separately for this dryer. This pedestal will add about 
11" (27.9 cm) to the height of your dryer for a total height of 
approximately 53" (134.6 cm).

For a garage installation, you will need to place the pedestal at 
least 7" (17.8 cm) above the floor.  

To order, call the dealer from whom you purchased your dryer or 
refer to the “Assistance or Service” section of this manual. Ask 
for Part Number LAV2701RSS.

Would you like to change your dryer door swing from a right-side 
opening to a left-side opening? To do so, you will need to 
purchase a Door Reversal Kit.

To order, call the dealer from whom you purchased your dryer or 
refer to the “Assistance or Service” section of this manual. Ask 
for Part Number 8182652.

■

Flat-blade screwdriver

■

#3 Phillips screwdriver

■

8" or 10" pipe wrench

■

8" or 10" adjustable 
wrench (for gas 
connections)

■

⁹⁄₁₆" (14 mm) open-end 
wrench (for adjusting dryer 
feet)

■

Level

■

Vent clamps

■

Caulking gun and 
compound (for installing 
new exhaust vent)

■

Tin snips (new vent 
installations)

■

¹⁄₄

" nut driver or socket 

wrench (recommended)

■

Pipe-joint compound 
resistant to LP gas

■

Pliers

■

Tape measure

A

C

B