Oregon Scientific WMR100NA ユーザーズマニュアル

6

3.  Insert the versatile plastic base into the pole.  Align the 

holes of the pole with the holes of the plastic base.

4.  Secure the plastic base by inserting the screw and 

screwing it tightly into the holes of the plastic base 
and pole.

 IMPORTANT  The 
sensor should be 
positioned in an open 
area away from trees or 
other obstructions.

5.  Hammer pole (cone end down) into the ground at the 

desired spot until versatile plastic base is level with 
the ground.

 TIP  Place a block of wood between the pole and the 
hammer to prevent damage to the pole.

6.  Assemble middle pole on top of the bottom one. 
7.  Using two screws, fix it firmly into place.
8.  Assemble top pole on top of the middle one.
9.  Using two screws, fix it firmly into place.

10. Slide the vertical attachment bracket on top of the top 

pole.

11. Using two screws, fix it firmly into place.

12. Slide  outdoor  sensor  onto  vertical  attachment 

bracket.

 

13. Insert the wind vane into the attachment bracket.
14. Screw aluminium pole firmly into place. 

 IMPORTANT  For best results, point the wind vane North.

15. Insert the 2 rectangular base legs through the holes 

of the versatile base and hammer down.

16. Using the string, tie a knot on the eye pins.  Hammer 

each eye pin into the ground at a 90° angle.

 IMPORTANT  Using 
the fasteners, tighten 
the string.  To tighten, 
pull fastener down.  
To loosen, thread the 
string up through the 
fastener eyelets.

1.  Secure  the  plastic  base  onto  existing  pole  with  U-

bolts, washers and bolts.

2.  Insert  the  horizontal  attachment  bracket  into  the 

base.

3.  Using a screw, fix firmly into place.