Olympus 260116 ユーザーズマニュアル

EN

When using the electronic flash with a camera without communication 
capability, adjust the ISO sensitivity and aperture value in AUTO mode 
to the same values as on the camera or change the shooting distance 
in MANUAL mode.
You can also emit the flash wirelessly as a slave flash. 

g “Slave 

flash” (P. 40)

In this mode, the flash light intensity is controlled automatically 
according to the aperture setting.

ISO sensitivity

Aperture value

Dial B

Dial A

  Turn dial A to adjust the ISO sensitivity.

  Press the ZOOM button to adjust the 

firing angle according to the focal 
distance of the lens.

  Turn dial B according to the aperture 

value of the lens.

 If the ISO sensitivity/aperture value 

combinations do not match the usable 
range, the ISO sensitivity and aperture 
value blink to alert you. In this case, 
change the ISO sensitivity and/or aperture 
value. 

g “Light control range in AUTO 

mode” (P. 47)

 Press the TEST button to test the flash 

activation. 

g “Test flash activation” (P. 16) 

  When flash activation has been 

performed correctly, the AUTO CHECK 
lamp blinks for about 5 seconds after 
the shutter is released.

ZOOM button

AUTO CHECK 
lamp

By selecting an ISO sensitivity and aperture value different from those set on the 
camera, the flash intensity can be adjusted in 1/3 steps.

TEST button

e00_r2062_cs2j.indb   38

e00_r2062_cs2j.indb   38

2007/08/01   14:44:01

2007/08/01   14:44:01