Olympus d-380 ユーザーズマニュアル
Taking still pictures
30
Shooting bas
ic
s
Taking still pictures using the monitor
1
Open the lens barrier.
2
Press .
The monitor turns on.
“Monitor indications” (
“Monitor indications” (
3
Determine the image composition
while observing your subject on the
monitor.
while observing your subject on the
monitor.
4
Take the picture by following the
same procedure as for shooting
using the viewfinder.
same procedure as for shooting
using the viewfinder.
Press the shutter button all the way (fully) to take the picture.
“Taking still pictures using the viewfinder” (
“Taking still pictures using the viewfinder” (
When you want to take pictures with the monitor off, press
again.
• While the green lamp is blinking after the shutter button is pressed
halfway, the flash is charging. While the green lamp is blinking after
shooting, the picture you just took is being stored. Wait until the lamp
goes off to take another picture (approx. 2 to 40 seconds).
shooting, the picture you just took is being stored. Wait until the lamp
goes off to take another picture (approx. 2 to 40 seconds).
• If the memory gauge is fully lit, you cannot take any pictures. Wait a
few seconds until the memory gauge goes off to take another picture.
• The monitor is used for checking the image composition. Camera
shake, the correct focus and exposure condition of the recorded
picture should be checked by the close-up playback. “Close-up
playback” (
picture should be checked by the close-up playback. “Close-up
playback” (